In this paper, we report a simple solution processed perovskite/polymer solar cell using CH3NH3PbI3 as an absorber, PCBM (6,6 phenyl C61-butyric acid methyl ester) as an electron transport layer, and PEDOT:PSS (poly (3,4-ethylene dioxy thiophene):poly(styrene sulfonate)) as a hole transport layer. The absorber solution was prepared by mixing of CH3NH3I (methyl ammonium iodide) with PbI2 (lead iodide) in DMF (dimethyl formamide) solvent. The absorber, electron transport, and hole transport layers are deposited by spin coating of the solutions. In order to obtain the optimum optical and electrical characteristics, the mixture of CH3NH3I and PbI2 are varied by the molar ratio of 1:1, 1:3, and 3:1, respectively. Because of CH3NH3PbI3 layer degrades, the fabricated cells have low performance. However, the cell using a molar ratio of 1:1 CH3NH3I and PbI2 gives the best electrical characteristics, results in an open circuit voltage of 0.04 V, a short circuit current density of 0.08 mA/cm 2 , and a power conversion efficiency of 0.002 %.Keywords: perovskite solar cell, CH3NH3PbI3, CH3NH3I, PbI2, PCBM, PEDOT/PSS ABSTRAK Di dalam tulisan ini kami melaporkan proses pembuatan sel surya berbasis perovskite/polimer yang diproses dalam bentuk larutan. Sel surya perovskite/polimer menggunakan CH3NH3PbI3 sebagai lapisan penyerap cahaya, PCBM (6,6 phenyl C61-butyric acid methyl ester) sebagai lapisan transport elektron, dan PEDOT:PSS (poly (3,4-ethylene dioxy thiophene):poly(styrene sulfonate)) sebagai lapisan transport hole. Larutan penyerap cahaya dibuat dengan mencampurkan CH3NH3I (metil amonium iodida) dan PbI2 (timbal iodida) dengan pelarut DMF (dimetil formamida). Lapisan-lapisan penyerap cahaya, transport elektron, dan transport hole dibuat dengan cara mendeposikan larutan-larutan tersebut menggunakan metoda spin coating. Untuk mendapatkan karakteristik listrik dan optik yang optimum campuran CH3NH3I dan PbI2 divariasikan dengan perbandingan molar masing-masing 1:1, 1:3, dan 3:1. Karena lapisan lapisan perovskite CH3NH3PbI3 mengalami degradasi, sel yang dibuat mempunyai perfomansi rendah. Namun demikian, sel yang menggunakan perbandingan molar CH3NH3I dan PbI2 1:1 memberikan karakteristik listrik yang paling baik, dengan tegangan sirkit terbuka sebesar 0,04 V, densitas arus sirkit pendek sebesar 0,08 mA/cm 2 , dan efisiensi konversi energi sebesar 0,002 %.Kata Kunci: sel surya perovskite, CH3NH3PbI3, CH3NH3I, PbI2, PCBM, PEDOT:PSS 12 Shobih, et. al.,