Effects of different remineralizing agents on color stability and surface characteristics of the teeth following vital bleaching

Bilge, Kübra; Kılıç, Vahti

doi:10.1002/jemt.23774

Cited by 4 publications

(10 citation statements)

References 47 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Additional analyses based on optical profilometry will include a quantitative evaluation of enamel’s surface roughness. Contrary to these findings, others [ 7 , 12 ] have shown that enamel surface properties were negatively impacted by bleaching protocols modulated by high-concentrated bleaching gels (either 30% or 40% HP), independently of their pH values (either acidic or neutral), using similar AFM techniques. Therefore, it could be assumed that the compositions tested have the potential to resolve mild-to-severe dental discolorations without negatively impacting the chemical arrangement or surface properties of treated enamel.…”

Section: Discussionmentioning

confidence: 84%

“…Even though several reports have demonstrated the bleaching efficacy of IPB [ 4 , 5 , 6 ], other studies have indicated that the utilization of these highly caustic bleaching agents may result in the occurrence of adverse effects (short- and long-term), including irreversible changes in enamel topography [ 7 ] and chemical make-up [ 8 , 9 , 10 ], decreased surface microhardness [ 11 ], increased surface roughness [ 12 ], diminished bond strength [ 13 ], and reduced fracture resistance [ 14 ]. From the clinical standpoint, the most prevalent adverse effect reported by patients and clinicians is mild to severe dentin hypersensitivity (DH) [ 4 , 15 , 16 ].…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Novel Experimental In-Office Bleaching Gels Containing Co-Doped Titanium Dioxide Nanoparticles

et al. 2022

View full text Add to dashboard Cite

The present study reports on the development and testing of novel bleaching agents containing co-doped metaloxide nanoparticles (NP; 0%, 5%, 10% v/w) and hydrogen peroxide (HP, 0%, 6%, 15%, and 35%). Bovine blocks (n = 200, A = 36 mm2) were obtained and randomly distributed into experimental groups (n = 10/group). NPs were incorporated into gels before bleaching (3 sessions, 7 days apart, 30 min/session, irradiated with violet light-LT). Color changes (ΔE00, ΔWID), mineral content (CO32−, PO43−), and topography were assessed (spectrophotometer, ATR-FTIR, and AFM) before and after bleaching procedures (14 days). Metabolic status and three-dimensional components of non-disrupted Streptococcus mutans biofilms were investigated using a multimode reader and confocal microscopy. The results indicate that ΔE00 and ΔWID significantly increased with NPs’ concentrations and LT. The enamel’s mineral ratio was adversely impacted by HP, but alterations were less pronounced when using NP-containing gels. The enamel’s topography was not damaged by the bleaching protocols tested. The bioluminescence results show that bleaching protocols do not render latent antibacterial properties to enamel, and the confocal microscopy results demonstrate that the 3-dimensional distribution of the components was affected by the protocols. The proposed nanotechnology improved the bleaching efficacy of experimental materials independent of hydrogen peroxide or irradiation and did not adversely impact the enamel’s surface properties or its chemical content.

show abstract

Section: Discussionmentioning

confidence: 84%

Section: Introductionmentioning

confidence: 99%

Novel Experimental In-Office Bleaching Gels Containing Co-Doped Titanium Dioxide Nanoparticles

et al. 2022

View full text Add to dashboard Cite

show abstract

“…14 Every sample was sanded using the same technique with new carbide silicon abrasive paper. 11 The samples spent ten minutes in an ultrasonic machine to remove residues. 16 By measuring the distance between the incisal edge and the cementoenamel junction, and the mesiodistal dimension, the middle third of the labial surface of the crown was marked using a caliper.…”

Section: Methodsmentioning

confidence: 99%

“…9 This significantly lowers mineral loss and restores microhardness and roughness. 11 The objectives of the following study are to assess the impact of fluoridated dental products (toothpaste, mouth rinse, and fluoride varnish) on bleached tooth enamel's surface roughness and surface morphology when used before, after, or before and after the tooth bleaching process.…”

Section: Introductionmentioning

confidence: 99%

Impact of Fluoridated Dental Products on Surface Roughness and Morphology of Bleached Tooth Enamel: An In Vitro Study

Alsabeel,

Qasim

2024

Pharmacogn J.

View full text Add to dashboard Cite

Purpose: To assess the impact of fluoridated dental products (Toothpaste, mouth rinse, and fluoride varnish) on bleached tooth enamel's surface roughness (SR) and surface morphology when used before, after, or before and after the tooth bleaching process. Methods: A total of (64) bovine permanent incisors were prepared and divided into two main groups: Group (A) was treated before and after the bleaching. Group (B) was treated after bleaching only. The bleaching process used an Opalescence boost of 40% hydrogen peroxide. Each main group was divided into (4) subgroups: (A1, B1) Control, (A2, B2) treated with FluorKIN mouthrinse, (A3, B3) treated with FluorKIN toothpaste, (A4, B4) treated with Proshield FV. A profilometer was used to evaluate surface roughness. Also, to assess the morphological changes in the enamel surface, another (14) teeth samples were viewed under the SEM. Results: There was a statistically significant increase in SR after bleaching and a decrease in SR after treatment, and there was no statistically significant difference between the group receiving bleaching only and the group receiving preventive protocol before bleaching, confirmed by SEM analysis. The slightest increase in surface roughness was found in the fluoride varnish group, followed by the FluorKIN toothpaste group, then the FluorKIN mouthrinse group. Conclusion: According to the surface roughness means results in the present study, Surface roughness increased very little in the fluoride varnish group, followed by the toothpaste group and mouthrinse group, respectively.

show abstract

“…After the bleaching protocols were completed, the specimens were immersed in coffee prepared with 2 g of instant coffee powder (Nescafé Classic, Nestlé, Vevey, Switzerland) and 200 mL of boiling distilled water for 30 min per day for two weeks [ 15 ]. The solution was prepared freshly every day.…”

Section: Methodsmentioning

confidence: 99%

The Effect of In-Office Bleaching with Different Concentrations of Hydrogen Peroxide on Enamel Color, Roughness, and Color Stability

et al. 2023

View full text Add to dashboard Cite

The aim of this study is to evaluate the effectiveness of in-office bleaching in esthetic dentistry on the roughness and color stability of the enamel surface, using different concentrations of hydrogen peroxide (HP). Fifty human incisors were randomly divided into 5 groups (n = 10). No bleaching was performed in the control group. For these groups, concentrations of 40% HP with fluoride (F), 35% HP with calcium (Ca), 25% HP with nano-hydroxyapatite (nHA) and 18% HP with nHA were used for bleaching in the test groups. Surface roughness was assessed at baseline after bleaching occurred. Color measurements were first obtained at baseline, then after the first and second sessions of bleaching, and, finally, after the staining protocol. Scanning electron microscopy and atomic force microscopy were performed. Statistical analysis was conducted with a one-way ANOVA, followed by a post hoc Tukey’s test and a paired-samples t-test (p < 0.05). All the bleaching gels used exhibited a similar color change (p > 0.05). Bleaching gels containing 18% HP with nHA and that containing 35% HP with Ca caused less surface roughness of the enamel. Of these concentrations, 25% HP with nHA caused the most surface roughness and no significant difference was observed, compared with 40% HP with F. The highest coloration after bleaching was observed in 40% HP with F and 25% HP with nHA. The lowest coloration was obtained in 35% HP with Ca and 18% HP with nHA but no significant difference was observed between them and the control group. A concentration above 18% HP does not increase the bleaching effectiveness. The results show that 18% HP with nHA and 35% HP with Ca resulted in the least increase in enamel surface roughness when compared to high-concentrate HP; however, it also prevented recoloration after bleaching.

show abstract

Effects of different remineralizing agents on color stability and surface characteristics of the teeth following vital bleaching

Cited by 4 publications

References 47 publications

Novel Experimental In-Office Bleaching Gels Containing Co-Doped Titanium Dioxide Nanoparticles

Novel Experimental In-Office Bleaching Gels Containing Co-Doped Titanium Dioxide Nanoparticles

Impact of Fluoridated Dental Products on Surface Roughness and Morphology of Bleached Tooth Enamel: An In Vitro Study

The Effect of In-Office Bleaching with Different Concentrations of Hydrogen Peroxide on Enamel Color, Roughness, and Color Stability

Contact Info

Product

Resources

About