Dynamic Bit Loading with the OGFDM Waveform Maximises Bit-Rate of Future Mobile Communications

2020

Information

Self Cite

On the brink of sophisticated generations of mobile starting with the fifth-generation (5G) and moving on to the future mobile technologies, the necessity for developing the wireless telecommunications waveform is extremely required. The main reason beyond this is to support the future digital lifestyle that tends principally to maximize wireless channel capacity and number of connected users. In this paper, the upgraded design of the multi-carrier orthogonal generalized frequency division multiplexing (OGFDM) that aims to enlarge the number of mobile subscribers yet sustaining each one with a high transmission capacity is presented, explored, and evaluated. The expanded multi-carrier OGFDM can improve the performance of the future wireless network that targets equally the broad sharing operation (scalability) and elevated transmission rate. From a spectrum perspective, the upgraded OGFDM can manipulate the side effect of the increased number of network subscribers on the transmission bit-rate for each frequency subcarrier. This primarily can be achieved by utilizing the developed OGFDM features, like acceleration ability, filter orthogonality, interference avoidance, subcarrier scalability, and flexible bit loading. Consequently, the introduced OGFDM can supply lower latency, better BW efficiency, higher robustness, wider sharing, and more resilient bit loading than the current waveform. To highlight the main advantages of the proposed OGFDM, the system performance is compared with the initial design of the multicarrier OGFDM side by side with the 5G waveform generalized frequency division multiplexing (GFDM). The experimented results show that by moving from both the conventional OGFDM and GFDM with 4 GHz to the advanced OGFDM with 6 GHz, the gained channel capacity is improved. Because of the efficient use of Hilbert filters and improved rate of sampling acceleration, the upgraded system can gain about 3 dB and 1.5 dB increments in relative to the OGFDM and GFDM respectively. This, as a result, can maximize mainly the overall channel capacity of the enhanced OGFDM, which in turn can raise the bit-rate of each user in the mobile network. In addition, by employing the OGFDM with the dual oversampling, the achieved channel capacity in worst transmission condition is increased to around six and twelve times relative to the OGFDM and GFDM with the normal oversampling. Furthermore, applying the promoted OGFDM with the adaptive modulation comes up with maximizing the overall channel capacity up to around 1.66 dB and 3.32 dB compared to the initial OGFDM and GFDM respectively. A MATLAB simulation is applied to evaluate the transmission performance in terms of the channel capacity and the bit error rate (BER) in an electrical back-to-back wireless transmission system.

Section: System Model Of Upgraded Multi-carrier Ogfdmmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Upgrading Physical Layer of Multi-Carrier OGFDM Waveform for Improving Wireless Channel Capacity of 5G Mobile Networks and Beyond

2020

Information

Self Cite

“…Through this paper, the utilised modulation formats for the frequency subcarriers vary from the low formats like the BPSK to the higher schemes as the 256 QAM which is proposed recently to the 5G technology [21,22].…”

Section: Experimental Workmentioning

confidence: 99%

Intra-channel Interference Avoidance with the OGFDM Boosts Channel Capacity of Future Wireless Mobile Communication

Advances in Intelligent Systems and Computing

Kanakis

Crockett

2019

Self Cite

The Orthogonal Generalized Frequency Division Multiplexing (OGFDM) with Intra-Channel Interference Avoidance (ICIA) approach is, for the first time, proposed, explored and evaluated. Since the interference manipulation currently represents a hot topic for wireless mobile communication, the conventional approach of mitigating the interference is no longer acceptable. As a result, a novel method for addressing the interference between adjacent filtered sub-carriers (inphase/out-phase) is comprehensively investigated herein. The proposed approach utilises the oversampling factor to effectively avoid interference and improve the quality of service of affected filters under bad transmission states. Thus, this supportive method which is essentially aware of propagation conditions is employed for removing the roll-off (α) impact yet improving the level of Bandwidth (BW) efficiency for applied filters of the OGFDM waveform. Besides, in terms of the system performance, the trade-off relation between the channel capacity and the key Hilbert filter parameter is theoretically and practically discussed. This requires investigation of the influence of α factor on the maximum achieved bitrate at the acceptable limit of the Bit Error Rate (BER). A MATLAB simulation was introduced to test the performance characteristics of the proposed system in the physical layer (PHY) of an electrical back-to-back wireless transmission system.

“…The adaptive modulation format is broadly utilized with the introduced multi-carrier OGFDM system to access the highest level of the BW efficiency. Thus, the same frequency subcarriers can possibly be reused in a better way depending on transmission conditions [20].…”

Section: Introductionmentioning

confidence: 99%

New Multi-Carrier Candidate Waveform For the 5G Physical Layer of Wireless Mobile Networks

2019 Wireless Days (WD)

2019

In this paper, a new multi-carrier candidate waveform for the future generation of mobile (5G) is introduced, explored and evaluated. The newly developed design of the Orthogonal Generalized Frequency division multiplexing (OGFDM) can improve the performance in terms of the channel capacity and Bit Error Rate (BER) for the wireless transmission of the multi-carrier system. In addition, compared to the most candidate waveform, Generalized Frequency Division Multiplexing (GFDM), the innovative multi-carrier OGFDM can double, boost and even maximize the capacity of wireless channel at the acceptable level of the BER. This is essentially achieved due to major adaptations have been made on the Filtration level, Oversampling level and Modulation level of the currently recommended GFDM. Thus, depending on the Digital Hilbert Filter (DHF), the presented solution can attain the orthogonality between the un-orthogonal filtered subcarriers of the multicarrier GFDM technique. Moreover, by utilizing an adjustable oversampling factor, the examined system can stay reliable even in the worst conditions of the wireless channel. Furthermore, employing the adaptive bit loading instead of the fixed modulation format, the announced waveform can reach the maximum rate of transmission with the venial limit of error. The main parameters of each promoted level are precisely specified in accordance with the optimum system performance. Besides, the different levels of the multi-carrier OGFDM are presented in the physical layer (PHY) of a wireless electrical back-to-back transceiver system. A MATLAB simulation was introduced to evaluate the system performance (BER & channel capacity) in presence of the Additive White Gaussian Noise (AWGN).