Design and implementation of PC to PC data transmission using wireless visible light communication system

Abstract

In this paper a laser-based <span>visible light communication system for PC to PC data transmission has been designed, simulated, and implemented. This type of communication uses light waves in the visible spectrum (380 nm to 750 nm) to deliver data. Visible light communication is any way of transmitting data using visible light. In order to avoid being detected by human eyes, this kind of communication sends information at a slower rate than human vision. Visible light communication is significantly more reliable and capable of high information transmission rates than existing wireless technologies such as Wi-Fi, Bluetooth, and others that use radio frequency spectrum. Laser-based visible light communication systems are low-cost, low-power, and do not require radio interference studies. A diode laser is frequently used to create the signal carrier. Due to its high efficiency, it can transmit data as well as illuminate. Light waves can't be intercepted because they can't penetrate opaque objects, signifying a very secure connection.</span>

Optimize single line to ground fault detection in distribution grid power system using artificial bee colony

“…Also, can either replace an entire controller with a eZdsp F28335 prototyping system or test new functions by bypassing an existing production controller and all this without manual programming. then the Simulink block diagram design is automatically executing on the system and calculated in real-time therefor eZdsp F28335 offers a wide range of hardware and software components [24], [25]. Figure 5 shows the stages of operation in the laboratory by using MATLAB and eZdsp F28335.…”

Post-quantum Techniques in Wireless Network Security: An Overview

“…Researchers work under this premise while designing and assessing new cryptosystems. Once a quantum computer is created, public-key cryptography and digital signatures will be rendered useless [13,14]. This section delves into the state of the art and future prospects for secure cryptosystems in the post-quantum era.…”

Assessment of control and monitoring system design security using the attack security tree analysis method

“…Naoual et al [24] system availability depending if system will pass the failure period and the result will be the same before failure, in the Table 1 the system availability using ATA, and measuring the degree of possibility system will be failure. All value of parameters applied ( 6)- (10) to get the final result [25].…”