Control Strategy for Maximum Power Point Tracking of Doubly Fed Induction Motor for Wind Turbine

Ibrahim, Ahmed; Solomin, Evgeny; Miroshnichenko, A.A.

doi:10.1109/uralcon.2018.8544372

Cited by 7 publications

(3 citation statements)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…where V b is the voltage of each battery. On the other hand, the number of parallel batteries can be calculated from the following Equation (18):…”

Section: Bess Modelingmentioning

confidence: 99%

“…In [17], the authors have proposed a performance study of a variable speed wind turbine based on the doublyfed induction generator by a matrix converter by employing the maximum power point tracking method to derive the maximum available power. In [18], the objective was to introduce a maximum power point tracking (MPPT) strategy for a wind turbine and investigate its steady-state behavior using MATLAB/SIMULINK. In [19], the modeling, stability, and control analysis of the DFIGs are discussed for wind turbines (WTs).…”

Section: Introductionmentioning

confidence: 99%

See 1 more Smart Citation

Introducing a New Method for Tracking and Transmitting Maximum Power of a Wind Power Plant to the Grid During Wind Shortages

Moradi

2020

IJE

View full text Add to dashboard Cite

The present paper proposes a novel vector control based method to connect a wind plant equipped with a Doubly-Fed Induction Generator to the grid. It also provides separate control capacity of injection power to the grid under wind shortages in addition to optimum performance in normal climatic conditions. The mathematical modeling of converters of the grid and rotor side is presented, which provides such a control tool. The idea of using an energy storage system has been presented to reduce power swings of the wind plant to grid in the dc-link of back-to-back converter of the rotor side. In order to achieve an optimal control system, the strategy of maximum wind power tracking and unit power factor of the wind farm are included in the control system. However, the power exchange strategy with the unit power factor is related to the type of operation of the grid, and reactive injection power can also be controlled when needed. Finally, a simulation of the studied system and the proposed control system in the SIMULINK environment of MATLAB software is presented, which provides a powerful tool for these types of systems. The results obtained from the conducted studies on a sample system demonstrate the efficiency and accuracy of the proposed method.

show abstract

“…where V b is the voltage of each battery. On the other hand, the number of parallel batteries can be calculated from the following Equation (18):…”

Section: Bess Modelingmentioning

confidence: 99%

Section: Introductionmentioning

confidence: 99%

Introducing a New Method for Tracking and Transmitting Maximum Power of a Wind Power Plant to the Grid During Wind Shortages

Moradi

2020

IJE

View full text Add to dashboard Cite

show abstract

“…In the early stages of WTG installation, the most challenging issue was how to adapt the turbine rotation with the rapid variation of the wind speed [6][7][8]. In [6], a maximum power point tracking (MPPT) system is used as a control strategy for optimal extraction of wind energy under the irregular variations of the wind speed. The MPPT control strategy has been also adopted for large-scale of WECS [7].…”

Section: Introductionmentioning

confidence: 99%

Application of SMES Technology in Improving the Performance of a DFIG-WECS Connected to a Weak Grid

et al. 2021

View full text Add to dashboard Cite

Wind Turbine Generator (WTG) has become one of the most popular renewable-based power generation that is broadly connected to electricity grids worldwide. Till the year 2019, the total WTGs installed worldwide reached about 650.8GW. The WTG is interfaced to the electricity grid through power electronic converters with a proper control algorithm to facilitate a smooth power delivery as well as maintaining the system voltage and frequency stability during wind intermittency. However, power grids are usually subjected to load expansion which affects the stiffness of the grid and hence its stability. A weak electricity grid exhibits voltage instability that may affect the performance of WTGs and in some cases may lead to serious damages to the wind turbines and the entire system. In this paper, superconducting magnetic energy storage (SMES) technology based on fuzzy logic controller is implemented to effectively resolve this issue and improve the overall performance of WTGs. Hysteresis current and fuzzy logic-based control system is proposed to control the energy exchange between the SMES coil and the investigated system. Results show the effectiveness of the SMES to improve the overall system performance and along with the fault ridethrough capability of the doubly-fed induction generator (DFIG).INDEX TERMS DFIG, SMES, Low voltage ride through, Wind energy, Weak grid.

show abstract

An Energy Storage Capacity Configuration Method for New Energy Power Stations to Improve Power Grid Stability

Chen

Jiang

Zhou

et al. 2023

2023 5th Asia Energy and Electrical Engineering Symposium (AEEES)

View full text Add to dashboard Cite

Control Strategy for Maximum Power Point Tracking of Doubly Fed Induction Motor for Wind Turbine

Cited by 7 publications

References 15 publications

Introducing a New Method for Tracking and Transmitting Maximum Power of a Wind Power Plant to the Grid During Wind Shortages

Introducing a New Method for Tracking and Transmitting Maximum Power of a Wind Power Plant to the Grid During Wind Shortages

Application of SMES Technology in Improving the Performance of a DFIG-WECS Connected to a Weak Grid

An Energy Storage Capacity Configuration Method for New Energy Power Stations to Improve Power Grid Stability

Contact Info

Product

Resources

About