1989
DOI: 10.2186/jjps.33.1350
| |Summarize |Cite
|
Sign up to set email alerts

Basic studies on cutting of composite resin cores.

Abstract: Abstract:Filler

Search citation statements

Order By: Relevance

Paper Sections

Select...
4
2
0
0

Citation Types

0
2
0
3

Year Published

Range
1993
1993
2015
2015

Publication Types

Select...
4

Relationship

0
4

Authors

Journals

Cited by 4 publications

(5 citation statements)

References 0 publications

0
2
0
3
Order By: Relevance
How the paper below cites the one you are viewing
“…alone was ground Previous studies on machinability have reported that the machining performance of diamond points decreases due to abrasive grain wear, declining with increase in number of runs 8,9,19,21) . The findings on composite resin machinability have been controversial, especially with regard to whether or not to decrease the number of runs when using a diamond point.…”
Section: Description Of Areas In Which Dentin
mentioning
confidence: 99%
“…Suggested causes for this roughness include differences in the mechanical properties of the composite resin and dentin and the manner in which the grinding tools are used. Most reports on the grinding efficiency of core build-up material 11,12,15,21) and on grinding tools 9) have evaluated resin cutting depth or grinding duration under constant loads. One study, which featured adjustments to the load on an air turbine hand-piece and feed rate 4) , reported on the relationship between load and machinability and between machinability and number of runs using a bur.…”
Section: Introduction
mentioning
confidence: 99%
See 1 more Smart Citation