Aspen Modeling of the Bayer Process

Langa, J. M.; Russell, Trevor; O’Neill, Gregory A.; Gacka, Philip; Shah, Virenkumar; Stephenson, Jerry L.; Snyder, Joan

doi:10.1007/978-3-319-48176-0_119

Cited by 1 publication

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…(a) Process simulation: Hydrometallurgical processes have been embedded in many commercial process simulation software, such as ASPEN [23] and HSC Sim [24]. The performance of a flashing system and the impact of the process parameters on its production efficiency can be studied and analyzed using the above software.…”

Section: Research Of Flashing In Pressure Hydrometallurgymentioning

confidence: 99%

An Overview of Flashing Phenomena in Pressure Hydrometallurgy

Liu

Zhou

et al. 2023

Processes

View full text Add to dashboard Cite

Pressure hydrometallurgy has attracted much attention for its characteristics, such as the high adaptability of raw materials and environmental friendliness. Flashing (flash boiling or flash evaporation) refers to the phase change phenomenon from liquid to gas triggered by depressurization, which is an important connection between high-pressure processes and atmospheric ones in pressure hydrometallurgy. This paper takes the flashing process in zinc leaching and alumina Bayer processes as examples, describes the flashing process in pressure hydrometallurgy in detail for the first time, and shows the importance of the flashing process in energy recovery, solution concentration, and liquid balance, as well as increasing equipment life. According to solid holdup (the volume percentage of solid), this paper proposes to divide the flashing process into solution flashing (low solid holdup) and slurry flashing (high solid holdup). A further focus is put on reviewing the state of the art of related studies. The results reveal that the research on the flashing process in pressure hydrometallurgy is scarce and often oversimplified, e.g., ignoring the BPE (boiling point elevation) and NEA (non-equilibrium allowance) in solution flashing and the effect of solid particles in slurry flashing. Computational fluid dynamic (CFD) simulation is a promising tool for investigating the flashing process. Based on the progress made in other fields, e.g., seawater desalination, nuclear safety analysis, and engine fuel atomization, we suggest that solution flashing can be studied using the CFD–PBM (population balance model) coupled two-fluid model, since a wide size range of bubbles will be generated. For slurry flashing, the effect of solid holdup on the bubble nucleation rate and mechanism as well as other bubble dynamics processes should be accounted for additionally, for which a quantitative description is still lacking. Meanwhile, data for validating the numerical method are scarce because of the harsh experimental conditions, and further research is needed. In summary, this work presents an overview of the flashing processes in pressure hydrometallurgy and some guidelines for future numerical studies.

show abstract

Section: Research Of Flashing In Pressure Hydrometallurgymentioning

confidence: 99%