Search citation statements

Order By: Relevance

Paper Sections

Select...
1
1
1
1

Citation Types

1
11
0

Year Published

2020
2020
2023
2023

Publication Types

Select...
8

Relationship

0
8

Authors

Journals

citations
Cited by 49 publications
(12 citation statements)
references
References 49 publications
1
11
0
Order By: Relevance
“…In the above plot when the slope is about 0.5, the electrochemical reaction occurs via a diffusion controlled process, while when slope is equal to 1, then the electrochemical reaction is adsorption controlled process. In the above equation the obtained slope is nearing to 1, confirming the adsorption controlled process [52][53][54][55]. Therefore, 6MP in the bulk solution was adsorbed and accumulated on the surface of S(O)MWCNT/MCPE firstly, then the electro-chemical oxidation reaction took place.…”
Section: Optimization Of CV Parameterssupporting
confidence: 54%
“…In the above plot when the slope is about 0.5, the electrochemical reaction occurs via a diffusion controlled process, while when slope is equal to 1, then the electrochemical reaction is adsorption controlled process. In the above equation the obtained slope is nearing to 1, confirming the adsorption controlled process [52][53][54][55]. Therefore, 6MP in the bulk solution was adsorbed and accumulated on the surface of S(O)MWCNT/MCPE firstly, then the electro-chemical oxidation reaction took place.…”
Section: Optimization Of CV Parameterssupporting
confidence: 54%
“…In addition, the electrochemical reaction of both modified electrodes is more controlled by surface confinement rather than by diffusion process. Since for the redox peaks (III/IV), the correlation coefficient R 2 of the plot of peak current against scan rate (Figure 11c for (1) and Figure 11d for (2)) is greater than that of the linear plot of current intensity vs the square root of scan rate (Figure 11e for (1) and Figure 11f for (2)) [21,55,56]. To verify the possibility to develop fructose sensor, the electrochemical impedance spectra (EIS) was measured for both modified electrodes with a wide range of fructose concentrations (Figure 12a,b,d,e).…”
Section: Electrochemical Behavior Of Hpc-co and Hpc-coo Modified Elecmentioning
confidence: 97%
“…They are found highly porous and can be manufactured at as low as room temperature through a simple process of geopolymerization among aluminum and silicon sources in an alkali medium [ 99 , 143 ]. Zeolites resembling geopolymers are appreciably useful for a variety of eco-friendly applications, viz., the taking away of heavy metals and photo-catalytic degradation of a few organic compounds, such as benzophenone, metronidazole, p-nitrophenol and eriochrome black T [ 145 , 146 , 147 , 148 , 149 , 150 ], along with some significant industrial uses, namely, diversion of methanol (CH 3 OH) to olefins and phenol hydroxylation for water and wastewater treatment.…”
Section: Applications Of Geopolymers For Water and Wastewater Treatmentmentioning
confidence: 99%