Potassium‐ion batteries (PIBs) are promising energy storage systems because of the abundance and low cost of potassium. The formidable challenge is to develop suitable electrode materials and electrolytes for accommodating the relatively large size and high activity of potassium. Herein, Bi‐based materials are reported as novel anodes for PIBs. Nanostructural design and proper selection of the electrolyte salt have been used to achieve excellent cycling performance. It is found that the potassiation of Bi undergoes a solid‐solution reaction, followed by two typical two‐phase reactions, corresponding to Bi ↔ Bi(K) and Bi(K) ↔ K5Bi4 ↔ K3Bi, respectively. By choosing potassium bis(fluorosulfonyl)imide (KFSI) to replace potassium hexafluorophosphate (KPF6) in carbonate electrolyte, a more stable solid electrolyte interphase layer is achieved and results in notably enhanced electrochemical performance. More importantly, the KFSI salt is very versatile and can significantly promote the electrochemical performance of other alloy‐based anode materials, such as Sn and Sb.

Layered α-Ni(OH) and its derivative bimetallic hydroxides (e.g., α-(Ni/Co)(OH)) have attracted much attention due to their high specific capacitance, although their insufficient cycling stability has blocked their wide application in various technologies. In this work, we demonstrate that the cycling performance of α-(Ni/Co)(OH) can be obviously enhanced via the intrinsic pillar effect of metaborate. Combining the high porosity feature of the metaborate stabilized α-(Ni/Co)(OH) and the improved electronic conductivity offered by graphene substrate, the average capacitance fading rate of the metaborate stabilized α-(Ni/Co)(OH) is only ∼0.0017% per cycle within 10 000 cycles at the current density of 5 A g. The rate performance is excellent over a wide temperature range from -20 to 40 °C. We believe that the enhancements should mainly be ascribed to the excellent structural stability offered by the metaborate pillars, and the detailed mechanism is discussed.

Spinel LiNi0.5Mn1.5O4 (LNMO) is a promising cathode candidate for the next‐generation high energy‐density lithium‐ion batteries (LIBs). Unfortunately, the application of LNMO is hindered by its poor cycle stability. Now, site‐selectively doped LNMO electrode is prepared with exceptional durability. In this work, Mg is selectively doped onto both tetrahedral (8a) and octahedral (16c) sites in the Fdtrue3‾ m structure. This site‐selective doping not only suppresses unfavorable two‐phase reactions and stabilizes the LNMO structure against structural deformation, but also mitigates the dissolution of Mn during cycling. Mg‐doped LNMOs exhibit extraordinarily stable electrochemical performance in both half‐cells and prototype full‐batteries with novel TiNb2O7 counter‐electrodes. This work pioneers an atomic‐doping engineering strategy for electrode materials that could be extended to other energy materials to create high‐performance devices.

Commonly observed variations in photoluminescence (PL) spectra of crystalline organic semiconductors, including the appearance or enhancement of certain PL bands, are shown to originate from a small amount of structural disorder (e.g., amorphous inclusions embedded in a crystal), rather than be necessarily related to chemical impurities or material oxidation. For instance, in rubrene, a minute amount of such disorder can lead to the appearance of a dominant PL band at 650 nm as a result of triplet excitons captured and fused at these sites, with a subsequent emission from the amorphous phase.