One of the key breakthroughs enabling flexible electronics with novel form factors is the deployment of flexible polymer films in place of brittle glass, which is one of the major structural materials for conventional electronic devices. Flexible electronics requires polymer films with the core properties of glass (i.e., dimensional stability and transparency) while retaining the pliability of the polymer, which, however, is fundamentally intractable due to the mutually exclusive nature of these characteristics. An overview of a transparent fiber‐reinforced polymer, which is suggested as a potentially viable structural material for emerging flexible/wearable electronics, is provided. This includes material concept and fabrication and a brief review of recent research progress on its applications over the past decade.

We report vinyl-phenyl siloxane hybrid material (VPH) that can be used as a matrix for copper-clad laminates (CCLs) for high-frequency applications. The CCLs, with a VPH matrix fabricated via radical polymerization of resin blend consisting of sol-gel-derived linear vinyl oligosiloxane and bulky siloxane monomer, phenyltris(trimethylsiloxy)silane, achieve low dielectric constant (Dk) and dissipation factor (Df). The CCLs with the VPH matrix exhibit excellent dielectric performance (Dk = 2.75, Df = 0.0015 at 1 GHz) with stability in wide frequency range (1 MHz to 10 GHz) and at high temperature (up to 275 °C). Also, the VPH shows good flame resistance without any additives. These results suggest the potential of the VPH for use in high-speed IC boards.

Sol-gel synthesized linear oligosiloxane-based hybrid material for a thermally-resistant light emitting diode (LED) encapsulant

Flexible microneedles are important tools that allow access to the inside of biological tissue from the outside without surgery. However, it had been hard to realize microneedle sensor arrays on flexible substrates because of the difficulty of attaining a needle with a high Young's modulus for a selected area on a thin or soft substrate. In this work, we developed a microneedle sensor on a hybrid substrate based on high Young's modulus epoxy siloxane for the microneedles and low Young's modulus polydimethylsiloxane for the conformable substrate. Polyaniline was deposited on the microneedle for pH sensing. The mechanical durability of the device was assessed by insertion into pig skin 1000 times. Last, the flexible microneedle pH sensors showed their utility for monitoring pH distribution in rats in a peripheral artery diseases model.

Herein, a highly adhesive LED encapsulant (HAEncap) is proposed based on a phenyl siloxane hybrid material with a high thermal stability, refractive index, and transparency which uses cost-effective radical polymerization.