The reaction mechanism of chitosan, bovine serum albumin (BSA), and gelatin with genipin (a natural crosslinking reagent) was examined with infrared, ultraviolet-visible, and 13 C NMR spectroscopies; protein-transfer reaction mass spectrometry; photon correlation spectroscopy; and dynamic oscillatory rheometry. Two reactions that proceeded at different rates led to the formation of crosslinks between primary amine groups. The fastest reaction to occur was a nucleophilic attack on genipin by a primary amine group that led to the formation of a heterocyclic compound of genipin linked to the glucosamine residue in chitosan and the basic residues in BSA and gelatin. The second, slower, reaction was the nucleophilic substitution of the ester group possessed by genipin to form a secondary amide link with chitosan, BSA, or gelatin. A decreased crosslinking rate in the presence of deuterium oxide rather than water suggested that acid catalysis was necessary for one or both of the reactions to proceed. The behavior of the gel time with polymer concentration was consistent with second-order gelation kinetics resulting from an irreversible crosslinking process, but was complicated by the oxygen radical-induced polymerization of genipin that caused the gels to assume a blue color in the presence of air. The lower elastic modulus attained after a given time during crosslinking of the globular protein BSA as compared to the coiled protein gelatin, despite possessing more crosslinkable basic residues, demonstrated the importance of protein secondary and tertiary structures in determining the availability of sites for crosslinking with genipin in protein systems.

We have investigated the effect of complexation of different phosphorus ligands on the stability, solid state structure, and spectroscopic properties (NMR, IR, UV-vis) of a 5,15-diphenyl-substituted ruthenium porphyrin, (MeOH)Ru(II)(CO)(DPP) 2 [DPP = 5,15-bis(3',5'-di-tert-butyl)phenyl-2,8,12,18-tetraethyl-3,7,13,17-tetramethylporphyrin]. The ligands used are PPh(3), diphenyl(phenylacetenyl)phosphine (DPAP), bis(diphenylphosphino)acetylene (DPPA), tris(phenylacetenyl)phosphine [(PA)(3)P], and diethyl (phenylacetenyl)phosphonite [PAP(OEt)(2)]. The mono-phosphine complexes (PR(3))Ru(II)(CO)(DPP) are readily formed in solution in quantitative yields. The complexes display association constants ranging from 1.2 x 10(4) M(-1) for PPh(3) to 4.8 x 10(6) M(-1) for PAP(OEt)(2). The weak association of PPh(3) does not correlate with its pK(a), delta((31)P), or cone angle value and is attributed to steric effects. Due to their kinetic lability, which is shown by 2D NMR spectroscopy, and the weakening of the carbonyl ligand via a trans effect, the mono-phosphine complexes could not be isolated. IR spectroscopy gives the relative order of pi-acceptor strength as PPh(3) < DPAP, DPPA < (PA)(3)P < PAP(OEt)(2), whereas the relative order of the sigma-donor strength is PPh(3) < (PA)(3)P < DPAP, DPPA < PAP(OEt)(2), based on the calculated pK(a) values and on the (31)P((1)H) NMR chemical shifts of the ligands. The chemical shift differences in the (31)P9(1)H)) NMR spectra upon ligand binding display a linear correlation with the calculated pK(a) values of the protonated ligands HPR(3)(+); we propose that the pK(a), and probably other electronic properties, of a specific phosphorus ligand can be estimated on the basis of the chemical shift difference Deltadelta((31)P) upon complexation to a metalloporphyrin. The bis-phosphine complexes can be isolated in pure form by crystallization from CHCl(3)-MeOH solutions using excess ligand. Association of the second ligand is in the same order of magnitude as the first binding for the phosphines, but the second phosphonite binding is decreased by a factor of about 100. The solid state structures show only marginal differences in the geometrical parameters. The calculated and the crystallographic cone angles of the ligands generally do not match, apart from the values obtained for PAP(OEt)(2).

Simultaneous coordination of an aromatic electron donor and acceptor to lithium leads to the formation of highly stable colored pseudorotaxane complexes (see picture). The lithium templated pseudorotaxane is an effective precursor to a [2]catenane.

No abstract

No abstract