Although two-dimensional monolayer transition-metal dichalcogenides reveal numerous unique features that are inaccessible in bulk materials, their intrinsic properties are often obscured by environmental effects. Among them, work function, which is the energy required to extract an electron from a material to vacuum, is one critical parameter in electronic/optoelectronic devices. Here, we report a large work function modulation in MoS2 via ambient gases. The work function was measured by an in situ Kelvin probe technique and further confirmed by ultraviolet photoemission spectroscopy and theoretical calculations. A measured work function of 4.04 eV in vacuum was converted to 4.47 eV with O2 exposure, which is comparable with a large variation in graphene. The homojunction diode by partially passivating a transistor reveals an ideal junction with an ideality factor of almost one and perfect electrical reversibility. The estimated depletion width obtained from photocurrent mapping was ∼200 nm, which is much narrower than bulk semiconductors.

We propose a design that increases significantly the absorption of a thin layer of absorbing material such as amorphous silicon. This is achieved by patterning a one-dimensional photonic crystal (1DPC) in this layer. Indeed, by coupling the incident light into slow Bloch modes of the 1DPC, we can control the photon lifetime and then, enhance the absorption integrated over the whole solar spectrum. Optimal parameters of the 1DPC maximize the integrated absorption in the wavelength range of interest, up to 45% in both S and P polarization states instead of 33% for the unpatterned, 100 nm thick amorphous silicon layer. Moreover, the absorption is tolerant with respect to fabrication errors, and remains relatively stable if the angle of incidence is changed.

Despite the direct band gap of monolayer transition metal dichalcogenides (TMDs), their optical gain remains limited because of the poor light absorption in atomically thin, layered materials. Most approaches to improve the optical gain of TMDs mainly involve modulation of the active materials or multilayer stacking. Here, we report a method to enhance the optical absorption and emission in MoS2 simply through the design of a nanostructured substrate. The substrate consisted of a dielectric nanofilm spacer (TiO2) and metal film. The overall photoluminescence intensity from monolayer MoS2 on the nanostructured substrate was engineered based on the TiO2 thickness and amplified by Fabry-Perot interference. In addition, the neutral exciton emission was selectively amplified by plasmonic excitations from the local field originating from the surface roughness of the metal film with spacer thicknesses of less than 10 nm. We further demonstrate that the quality factor of the device can also be engineered by selecting a spacer material with a different refractive index.