A pressure chamber is designed to study the crumpling process under an ambient force. The compression force and its resulting radius for the ball obey a power law with an exponent that is independent of the thickness and initial size of the sheet. However, the exponent is found to be material dependent and less than the universal value, 0.25, claimed by the previous simulations. The power-law behavior disappears at high pressure when the compressibility drops discontinuously, which is suggestive of a locked state.

The drain current fluctuation of ungated AlGaN/GaN high electron mobility transistors (HEMTs) measured in different fluids at a drain-source voltage of 0.5 V was investigated. The HEMTs with metal on the gate region showed good current stability in deionized water, while a large fluctuation in drain current was observed for HEMTs without gate metal. The fluctuation in drain current for the HEMTs without gate metal was observed and calculated as standard deviation from a real-time measurement in air, deionized water, ethanol, dimethyl sulfoxide, ethylene glycol, 1,2-butanediol, and glycerol. At room temperature, the fluctuation in drain current for the HEMTs without gate metal was found to be relevant to the dipole moment and the viscosity of the liquids. A liquid with a larger viscosity showed a smaller fluctuation in drain current. The viscosity-dependent fluctuation of the drain current was ascribed to the Brownian motions of the liquid molecules, which induced a variation in the surface dipole of the gate region. This study uncovers the causes of the fluctuation in drain current of HEMTs in fluids. The results show that the AlGaN/GaN HEMTs may be used as sensors to measure the viscosity of liquids within a certain range of viscosity.

No abstract

To provide coherent x-ray sources for probing the dynamic structures of solid or liquid biological substances on the picosecond timescale, a high-aspect-ratio x-ray resonator cavity etched from a single crystal substrate with a nearly vertical sidewall structure is required. Although high-aspect-ratio resonator cavities have been produced in silicon, they suffer from unwanted multiple beam effects. However, this problem can be avoided by using the reduced symmetry of single-crystal sapphire in which x-ray cavities may produce a highly monochromatic transmitted x-ray beam. In this study, we performed nominal 100 µm deep etching and vertical sidewall profiles in single crystal sapphire using inductively coupled plasma (ICP) etching. The large depth is required to intercept a useful fraction of a stopped-down x-ray beam, as well as for beam clearance. An electroplated Ni hard mask was patterned using KMPR 1050 photoresist and contact lithography. The quality and performance of the x-ray cavity depended upon the uniformity of the cavity gap and therefore verticality of the fabricated vertical sidewall. To our knowledge, this is the first report of such deep, vertical etching of single-crystal sapphire. A gas mixture of Cl2/BCl3/Ar was used to etch the sapphire with process variables including BCl3 flow ratio and bias power. By etching for 540 min under optimal conditions, we obtained an x-ray resonant cavity with a depth of 95 µm, width of ~30 µm, gap of ~115 µm and sidewall profile internal angle of 89.5°. The results show that the etching parameters affected the quality of the vertical sidewall, which is essential for good x-ray resonant cavities.

The spontaneous surface luminescence properties of InGaN/GaN quantum structure lattice (QSL) are reported. The QSL consists of a two-dimensional array of InGaN/GaN quantum boxes (QBs) arranged in a rectangular pattern of 200 nm periodicity. The measured angular dependent photoluminescence (PL) spectra show a strong dependence on the in-plane Bragg diffractions between QBs. The maximum PL intensity of the InGaN/GaN QSL array that fulfill the Bragg condition points in the normal direction of the sample surface with a narrow radiation angle of ∼ ±12°. In addition, a small side lobe is also shown at ±40°. For the QSL sample that does not fulfill the Bragg diffraction condition, the radiation pattern shows a conventional cosine distribution. The finite-difference time-domain numerical analysis confirms that the lowest order and higher order Bragg diffractions between QBs determine the main and the small side lobe of the radiation pattern measured in QSLs, respectively.