No abstract

The high prevalence of mcr-1 in multidrug-resistant E. coli colonizing humans is a clinical threat; diverse genetic mechanisms (strains/plasmids/insertion sequences) have contributed to the dissemination of mcr-1, and will facilitate its persistence.

High tensile strength Al-3Mg-0.5Sc alloy wires can be produced by a method called semi-solid continuous casting-extrusion and on-line solution process (CCES). The effects of artificial aging and the combination of the artificial aging and cold drawing on the microstructures and properties of alloy wires were respectively investigated. TEM observations reveal that a large number of dislocations and Al3Sc particles distributed in the Al-matrix of Al-3Mg-0.5Sc alloy produced by semi-solid CCES.After directly artificial aging (DAA), the tensile strength is 353MPa and elongation is 19.9%; After cold drawing following artificial aging (CDAA), the tensile strength is 378MPa and elongation is 17.7%; After artificial aging following cold drawing (AACD), the tensile strength is 435MPa and elongation is 10.4%.

The energy-saving effect of the injection molding machine energy-saving reformation project was measured in a factory. Based on the analysis of the project energy-saving principle, analyzed the energy-saving rate of the reformed injection molding machine in case of producing different products. The test results show that the active power saving rate is 50% under the load condition, the active power saving rate is more than 75% under the no-load condition and energy-saving effect is more obvious under the no-load condition. Finally, analyzed the power quality impact caused by the energy-saving equipment on the distribution network, put forward some suggestions for improvement.