Interactions between ceria (CeO2) and supported metals greatly enhance rates for a number of important reactions. However, direct relationships between structure and function in these catalysts have been difficult to extract because the samples studied either were heterogeneous or were model systems dissimilar to working catalysts. We report rate measurements on samples in which the length of the ceria-metal interface was tailored by the use of monodisperse nickel, palladium, and platinum nanocrystals. We found that carbon monoxide oxidation in ceria-based catalysts is greatly enhanced at the ceria-metal interface sites for a range of group VIII metal catalysts, clarifying the pivotal role played by the support.

We report an improved synthesis of colloidal gold nanorods (NRs) by using aromatic additives that reduce the concentration of hexadecyltrimethylammonium bromide surfactant to ~0.05 M as opposed to 0.1 M in well-established protocols. The method optimizes the synthesis for each of the 11 additives studied, allowing a rich array of monodisperse gold NRs with longitudinal surface plasmon resonance tunable from 627 to 1246 nm to be generated. The gold NRs form large-area ordered assemblies upon slow evaporation of NR solution, exhibiting liquid crystalline ordering and several distinct local packing motifs that are dependent upon the NR's aspect ratio. Tailored synthesis of gold NRs with simultaneous improvements in monodispersity and dimensional tunability through rational introduction of additives will not only help to better understand the mechanism of seed-mediated growth of gold NRs but also advance the research on plasmonic metamaterials incorporating anisotropic metal nanostructures.

Ammonium thiocyanate (NH(4)SCN) is introduced to exchange the long, insulating ligands used in colloidal nanocrystal (NC) synthesis. The short, air-stable, environmentally benign thiocyanate ligand electrostatically stabilizes a variety of semiconductor and metallic NCs in polar solvents, allowing solution-based deposition of NCs into thin-film NC solids. NH(4)SCN is also effective in replacing ligands on NCs after their assembly into the solid state. The spectroscopic properties of this ligand provide unprecedented insight into the chemical and electronic nature of the surface of the NCs. Spectra indicate that the thiocyanate binds to metal sites on the NC surface and is sensitive to atom type and NC surface charge. The short, thiocyanate ligand gives rise to significantly enhanced electronic coupling between NCs as evidenced by large bathochromic shifts in the absorption spectra of CdSe and CdTe NC thin films and by conductivities as high as (2 ± 0.7) × 10(3) Ω(-1) cm(-1) for Au NC thin films deposited from solution. NH(4)SCN treatment of PbTe NC films increases the conductivity by 10(13), allowing the first Hall measurements of nonsintered NC solids, with Hall effect mobilities of 2.8 ± 0.7 cm(2)/(V·s). Thiocyanate-capped CdSe NC thin films form photodetectors exhibiting sensitive photoconductivity of 10(-5) Ω(-1) cm(-1) under 30 mW/cm(2) of 488 nm illumination with I(photo)/I(dark) > 10(3) and form n-channel thin-film transistors with electron mobilities of 1.5 ± 0.7 cm(2)/(V·s), a current modulation of >10(6), and a subthreshold swing of 0.73 V/decade.

A simple yet efficient method to remove organic ligands from supported nanocrystals is reported for activating uniform catalysts prepared by colloidal synthesis procedures. The method relies on a fast thermal treatment in which ligands are quickly removed in air, before sintering can cause changes in the size and shape of the supported nanocrystals. A short treatment at high temperatures is found to be sufficient for activating the systems for catalytic reactions. We show that this method is widely applicable to nanostructures of different sizes, shapes, and compositions. Being rapid and effective, this procedure allows the production of monodisperse heterogeneous catalysts for studying a variety of structure-activity relationships. We show here results on methane steam reforming, where the particle size controls the CO/CO2 ratio on alumina-supported Pd, demonstrating the potential applications of the method in catalysis.

Doping is a process in which atomic impurities are intentionally added to a host material to modify its properties. It has had a revolutionary impact in altering or introducing electronic, magnetic, luminescent, and catalytic properties for several applications, for example in semiconductors. Here we explore and demonstrate the extension of the concept of substitutional atomic doping to nanometre-scale crystal doping, in which one nanocrystal is used to replace another to form doped self-assembled superlattices. Towards this goal, we show that gold nanocrystals act as substitutional dopants in superlattices of cadmium selenide or lead selenide nanocrystals when the size of the gold nanocrystal is very close to that of the host. The gold nanocrystals occupy random positions in the superlattice and their density is readily and widely controllable, analogous to the case of atomic doping, but here through nanocrystal self-assembly. We also show that the electronic properties of the superlattices are highly tunable and strongly affected by the presence and density of the gold nanocrystal dopants. The conductivity of lead selenide films, for example, can be manipulated over at least six orders of magnitude by the addition of gold nanocrystals and is explained by a percolation model. As this process relies on the self-assembly of uniform nanocrystals, it can be generally applied to assemble a wide variety of nanocrystal-doped structures for electronic, optical, magnetic, and catalytic materials.

Directed self-assembly of colloidal nanocrystals into ordered superlattices enables the preparation of novel metamaterials with diverse functionalities. Structural control and precise characterization of these superlattices allow the interactions between individual nanocrystal building blocks and the origin of their collective properties to be understood. Here, we report the directed liquid interfacial assembly of gadolinium trifluoride (GdF(3)) nanoplates into liquid crystalline assemblies displaying long-range orientational and positional order. The macroscopic orientation of superlattices is controlled by changing the subphases upon which liquid interfacial assembly occurs. The assembled structures are characterized by a combination of transmission electron microscopy (TEM) and small-angle X-ray scattering (SAXS) measurements performed on a laboratory diffractometer. By doping GdF(3) nanoplates with europium (Eu(3+)), luminescent phosphorescent superlattices with controlled structure are produced and enable detailed structural and optical characterization.

We report a size-controllable synthesis of monodisperse core/shell Ni/FePt nanoparticles (NPs) via a seed-mediated growth and their subsequent conversion to Ni/Pt NPs. Preventing surface oxidation of the Ni seeds is essential for the growth of uniform FePt shells. These Ni/FePt NPs have a thin (≈1 nm) FePt shell and can be converted to Ni/Pt by acetic acid wash to yield active catalysts for oxygen reduction reaction (ORR). Tuning the core size allows the optimization of their electrocatalytic activity. The specific activity and mass activity of 4.2/0.8 nm core/shell Ni/FePt after acetic acid wash reach 1.95 mA/cm(2) and 490 mA/mgPt at 0.9 V (vs reversible hydrogen electrode), which are much higher than those of benchmark commercial Pt catalyst (0.34 mA/cm(2) and 92 mA/mgPt at 0.9 V). Our studies provide a robust approach to monodisperse core/shell NPs with nonprecious metal core, making it possible to develop advanced NP catalysts with ultralow Pt content for ORR and many other heterogeneous reactions.

Photocatalytic pathways could prove crucial to the sustainable production of fuels and chemicals required for a carbon-neutral society. Electron−hole recombination is a critical problem that has, so far, limited the efficiency of the most promising photocatalytic materials. Here, we show the efficacy of anisotropy in improving charge separation and thereby boosting the activity of a titania (TiO 2 ) photocatalytic system. Specifically, we show that H 2 production in uniform, one-dimensional brookite titania nanorods is highly enhanced by engineering their length. By using complimentary characterization techniques to separately probe excited electrons and holes, we link the high observed reaction rates to the anisotropic structure, which favors efficient carrier utilization. Quantum yield values for hydrogen production from ethanol, glycerol, and glucose as high as 65%, 35%, and 6%, respectively, demonstrate the promise and generality of this approach for improving the photoactivity of semiconducting nanostructures for a wide range of reacting systems.titania | brookite | photocatalysis | photoreforming | hydrogen