This paper presents the automatic load frequency control (ALFC) of two-area multisource hybrid power system (HPS). The interconnected HPS model consists of conventional and renewable energy sources operating in disparate combinations to balance the generation and load demand of the system. In the proffered work, the stability analysis of nonlinear dynamic HPS model was analyzed using the Hankel method of model order reduction. Also, an attempt was made to apply cascade proportional integralproportional derivative (PI-PD) control for HPS. The gains of the controller were optimized by minimizing the integral absolute error (IAE) of area control error using particle swarm optimization-gravitational search algorithm (PSO-GSA) optimization technique. The performance of cascade control was compared with other classical controllers and the efficiency of this approach was studied for various cases of HPS model. The result shows that the cascade control produced better transient and steady state performances than those of the other classical controllers. The robustness analysis also reveals that the system overshoots/undershoots in frequency response pertaining to random change in wind power generation and load perturbations were significantly reduced by the proposed cascade control. In addition, the sensitivity analysis of the system was performed, with the variation in step load perturbation (SLP) of 1% to 5%, system loading and inertia of the system by ±25% of nominal values to prove the efficiency of the controller. Furthermore, to prove the efficiency of PSO-GSA tuned cascade control, the results were compared with other artificial intelligence (AI) methods presented in the literature. Further, the stability of the system was analyzed in frequency domain for different operating cases.INDEX TERMS Automatic load frequency control (ALFC), hybrid power system (HPS), cascade control scheme (CCs), proportional integral -proportional derivative (PI-PD) control, Hankel method, particle swarm optimization -gravitational search algorithm (PSO-GSA).

No abstract

No abstract

The large-scale penetration of intermittent renewable energy (RE) sources such as wind and solar power generation may cause a problem of frequency aberration, power quality and instability to the system. This occurs when the load frequency control of interconnected system is unable to compensate the power balance between generation and load demand. To overcome these issues, this paper proposes a method to analyze the frequency stability of Hybrid Power System (HPS) through adaptive intelligent control techniques for delivering reliable power supply under the stochastic nature of RE and load demand. A recently developed physics-inspired Atom Search Optimization algorithm was applied for tuning the parameters of Fractional Order Proportional-Integral-Derivative controller for Automatic Load Frequency control of HPS. In addition, an effort was made to analyze the frequency stability of HPS using Matignon's theorem. The interconnected HPS consists of reheat thermal power system, RE sources such as wind and solar thermal power generation associated with energy storage devices namely aqua electrolyzer, fuel cell and electric vehicle. The gain and fractional terms of the controller were obtained by minimizing the Integral Time Absolute Error of interconnected system. The robustness of ASO-tuned FOPID controller is tested on two-area HPS that was modelled using MATLAB/Simulink. The results obtained were then compared with other fractional order and classical integer order controllers. From the simulation results, it is inferred that the proposed ASO-tuned FOPID controller gives superior transient and steady-state response compared with other controllers. Moreover, the self-adaptiveness and robustness of the controller was validated to account for the change in RE power generations and system parameters. Furthermore, the effectiveness of the method is proved by comparing its performance with the recent literature works. The real-time applicability of proffered controller is validated in hardware-in-the-loop simulation using Real Time Digital Simulator.

The electric sector is majorly concerned about the greenhouse and non-greenhouse gas emissions generated from both conventional and renewable energy sources, as this is becoming a major issue globally. Thus, the utilities must adhere to certain environmental guidelines for sustainable power generation. Therefore, this paper presents a novel nature-inspired and population-based Harris Hawks Optimization (HHO) methodology for controlling the emissions from thermal generating sources by solving single and multi-objective Optimal Power Flow (OPF) problems. The OPF is a non-linear, non-convex, constrained optimization problem that primarily aims to minimize the fitness function by satisfying the equality and inequality constraints of the system. The cooperative behavior and dynamic chasing patterns of hawks to pounce on escaping prey is modeled mathematically to minimize the objective function. In this paper, fuel cost, real power loss and environment emissions are regarded as single and multi-objective functions for optimal adjustments of power system control variables. The different conflicting framed multi-objective functions have been solved using weighted sums using a no-preference method. The presented method is coded using MATLAB software and an IEEE (Institute of Electrical and Electronics Engineers) 30-bus. The system was used to demonstrate the effectiveness of selective objectives. The obtained results are compared with the other Artificial Intelligence (AI) techniques such as the Whale Optimization Algorithm (WOA), the Salp Swarm Algorithm (SSA), Moth Flame (MF) and Glow Warm Optimization (GWO). Additionally, the study on placement of Distributed Generation (DG) reveals that the system losses and emissions are reduced by an amount of 9.8355% and 26.2%, respectively.