No abstract

The aim of this study was to investigate the effect of torrefaction on the pyrolysis of rubber wood sawdust (RWS) using pyrolysis-gas chromatography/mass spectrometry (Py-GC/MS). Three typical torrefaction temperatures (200, 250, and 300 °C) and pyrolysis temperatures (450, 500, and 550 °C) were considered. The results suggested that only diethyl phthalate, belonging to esters, was detected at the torrefaction temperatures of 200 and 250 °C, revealing hemicellulose degradation. With the torrefaction temperature of 300 °C, esters, aldehydes, and phenols were detected, suggesting the predominant decomposition of hemicellulose and lignin. The double-shot pyrolysis indicated that the contents of oxy-compounds such as acids and aldehydes in pyrolysis bio-oil decreased with rising torrefaction temperature, implying that increasing torrefaction severity abated oxygen content in the bio-oil. With the torrefaction temperature of 300 °C, relatively more cellulose was retained in the biomass because the carbohydrate content in the pyrolysis bio-oil increased significantly.

No abstract

No abstract

SUMMARY Co‐gasification performance of coal and petroleum coke (petcoke) blends in a pilot‐scale pressurized entrained‐flow gasifier was studied experimentally. Two different coals, including a subbituminous coal (Coal A) and a bituminous coal (Coal B), individually blended with a petcoke in the gasifier were considered. The experimental results suggested that, when the petcoke was mixed with Coal A over 70%, the slagging problem, which could shorten the operational period due to high ash content in the coal, was improved. It was found that increasing O2/C tended to decrease the syngas concentration and better operational conditions of O2/C were between 0.6 and 0.65 Nm3 kg−1. For the blends of Coal B and the petcoke, the slagging problem was encountered no more, as a result of low ash content in both Coal B and the petcoke. The better co‐gasification performance could be achieved if the blending ratio of the two fuels was 50%, perhaps resulting from the synergistic effect of the blends. With the aforementioned blending ratio, the optimal condition of O2/C was located at around 0.65 Nm3 kg−1. The co‐gasification was also simulated using Aspen Plus. It revealed that the simulation could provide a useful insight into the practical operation of co‐gasification. Copyright © 2011 John Wiley & Sons, Ltd.