This study presents results that show that the fine structure of arabinoxylan affects its interaction with cellulosic surfaces, an important understanding when designing and evaluating properties of xylan-cellulose-based materials. Arabinoxylan samples, with well-defined structures, were prepared from a wheat flour arabinoxylan with targeted enzymatic hydrolysis. Turbidity measurements and analyses using NMR diffusometry showed that the solubility and the hydrodynamic properties of arabinoxylan are determined not only by the degree of substitution but also by the substitution pattern. On the basis of results obtained from adsorption experiments on microcrystalline cellulose particles and on cellulosic model surfaces investigated with quartz crystal microbalance with dissipation monitoring, it was also found that arabinoxylan adsorbs irreversibly on cellulosic surfaces and that the adsorption characteristics, as well as the properties of the adsorbed layer, are controlled by the fine structure of the xylan molecule.

No abstract

The inherent flammability of cellulosic fibers limits their use in some advanced applications. This work demonstrates for the first time the production of flame-retardant macroscopic fibers from wood-derived cellulose nanofibrils (CNF) and silica nanoparticles (SNP). The fibers are made by extrusion of aqueous suspensions of anionic CNF into a coagulation bath of cationic SNP at an acidic pH. As a result, the fibers with a CNF core and a SNP thin shell are produced through interfacial complexation. Silica-modified nanocellulose fibers with a diameter of ca. 15 μm, a titer of ca. 3 dtex and a tenacity of ca. 13 cN tex are shown. The flame retardancy of the fibers is demonstrated, which is attributed to the capacity of SNP to promote char forming and heat insulation on the fiber surface.

Microfluidic fiber spinning is a promising technique for assembling cellulose nanomaterials into macroscopic fibers. However, its implementation requires upscalabe fabrication processes while maintaining high strength of the fibers, which could not be previously achieved. Herein, a continuous wet spinning process based on microfluidic flow focusing is developed to produce strong fibers from cellulose nanofibrils (CNFs) and nanocrystals (CNCs). Fibers with an average breaking tenacity as high as 29.5 cN tex−1 and Young's modulus of 1146 cN tex−1 are reported for the first time, produced from nonhighly purified CNF grades. Using the same developed method, wet spinning of fibers from CNCs is achieved for the first time, reaching an average Young's modulus of 1263 cN tex−1 and a breaking tenacity of 10.6 cN tex−1, thus exhibiting strength twice as high as that of common CNC films. A rather similar stiffness of CNC and CNF spun fibers may originate from similar degrees of alignment, as confirmed by wide‐angle X‐ray scattering (WAXS) and birefringence measurements, whereas lower strength may primarily arise from the shorter length of CNCs compared to that of CNFs. The benefit of CNCs is their higher solids content in the dopes. By combining both CNCs and CNFs, the fiber properties can be tuned.