Single-wall and multiwall carbon nanotubes are employed as carbon supports in direct methanol fuel cells (DMFC). The morphology and electrochemical activity of single-wall and multiwall carbon nanotubes obtained from different sources have been examined to probe the influence of carbon support on the overall performance of DMFC. The improved activity of the Pt-Ru catalyst dispersed on carbon nanotubes toward methanol oxidation is reflected as a shift in the onset potential and a lower charge transfer resistance at the electrode/electrolyte interface. The evaluation of carbon supports in a passive air breathing DMFC indicates that the observed power density depends on the nature and source of carbon nanostructures. The intrinsic property of the nanotubes, dispersion of the electrocatalyst and the electrochemically active surface area collectively influence the performance of the membrane electrode assembly (MEA). As compared to the commercial carbon black support, single wall carbon nanotubes when employed as the support for anchoring the electrocatalyst particles in the anode and cathode sides of MEA exhibited a approximately 30% enhancement in the power density of a single stack DMFC operating at 70 degrees C.

No abstract

This paper discusses a pulse electroplating method for developing tin (Sn)-decorated gas diffusion electrodes (GDEs) for the electrochemical conversion of carbon dioxide (CO2) to formate. The pulse-plated Sn electrodes achieved current densities up to 388 mA/cm2, more than two-fold greater than conventionally prepared electrodes (150 mA/cm2), both at a formate selectivity of 80%. Optical and microscopic analyses indicate improvements in deposition parameters could further enhance performance by reducing the catalyst particle size.

A pulse reverse electrochemical surface finishing process for electropolishing passive materials is described. Unlike conventional electrochemical surface finishing processes, the pulse reverse process does not require low conductivity/high viscosity electrolytes and does not require the addition of chemical species to remove the passive film associated with electropolishing of passive and strongly passive materials. This paper focuses on pulse/pulse reverse electropolishing of niobium.