No abstract

The specific conductivity of several oil-in-water (o/w) microemulsions (MEs) stabilized by sodium dodecyl sulfate and 1-butanol was measured at 25 °C as functions of the volume fraction of oil (φ0) and the molar ratio of water to surfactant (R). The oils used are octane, benzene, toluene, carbon tetrachloride, chloroform, cyclohexane, xylene, and nitrobenzene. The conductivity data were explained by the modified Bruggeman equation in the entire experimental range of φ0 in the case of octane and nitrobenzene and in a limited range of φ0 in the case of other oils. The value of the slope of this equation, f, is found to depend on (i) the concentration of surfactant or the R value, (ii) the nature of the oil, and (iii) the nature and number of substituents, if the oil is a substituted benzene. The specific conductivity data of o/w MEs of R ) 120 and 100 were also analyzed in the light of the mixed electrolyte model, and the values of aggregation number, counterion binding constant, and radius of droplet were computed.

The critical micelle concentrations (CMC) of cetylpyridinium chloride (CPC) in water/glycerol media and in the presence of sodium chloride were determined at 25°C by surface tension and conductance methods. Variation in CMC follows the normal trend, i.e., it increases with increases in glycerol content and decreases on adding NaCl. Empirical analysis of the exponential increase in CMC of CPC with weight per cent of glycerol is indicative of CMC having two components; one component being dependent while the other independent of the glycerol amount. The counter ion binding constant was determined from both slope-ratio and Corrin-Harkins methods and showed no dependence on glycerol amount, thus confirming the unusual trend in the behavior of b in water/glycerol media. In a water/glycerol medium, the ratio of solvent surface tension to limiting surface tension at CMC is also independent of the glycerol amount, whereas the Gordon Parameter decreases with increasing glycerol content as in other aqueous organic solvents. The air-solution interface becomes saturated by the adsorption of CPC when the concentration of added NaCl is about 0.02 mol kg -1 irrespective of the glycerol amount.

No abstract