A one-pot electrochemical nickel-catalyzed decarboxylative sp2–sp3 cross-coupling reaction has been developed using redox-active esters prepared in situ from alkyl carboxylates and N-hydroxyphthalimide tetramethyluronium hexafluorophosphate (PITU). This undivided cell one-pot method enables C–C bond formation using inexpensive, benchtop-stable reagents with isolated yields up to 95% with good functional group tolerance, which includes nitrile, ketone, ester, alkene and selectivity over other aromatic halogens.

The rate constants for the aqueous reaction, between pH 0 and 14, have been determined for a series of amide substituted N-(hydroxybenzyl)benzamide derivatives, in H 2 O, at 25 °C, I = 1.0 M (KCl). The N-(hydroxybenzyl)benzamide derivatives were found to react via three distinct mechanisms with the kinetically dominant mechanism being dependent on the pH of the reaction solution. It has been shown that the carbinolamides react via a specific-basecatalyzed mechanism (E1cB-like) under basic and pH neutral conditions. At lower pH values, an acid-catalyzed mechanism was kinetically dominant and, last, a water reaction was postulated at pH values where neither the hydroxidedependent nor the general-acid-catalyzed mechanism was dominant. Contrary to earlier studies with N-(hydroxymethyl)benzamide compounds, no evidence for mechanistic variation based upon the nature of the amidic substituent was observed for any of the N-(hydroxybenzyl)benzamide derivatives studied between pH values of 0−14. The rate for the acid-catalyzed reaction (k H , ρ = −1.17), the apparent second-order hydroxide rate constant (k 1 ′, ρ = 0.87), the hydroxide-independent rate (k 1 , ρ = 0.65), and the pK a 's of the hydroxyl group of the carbinolamide (ρ = 0.23) are reported.

Extremophile archaeal organisms overcome problems of membrane permeability by producing lipids with structural elements that putatively improve membrane integrity compared to lipids from other life forms. Herein, we describe a series of lipids that mimic some key structural features of archaeal lipids, such as: 1) single tethering of lipid tails to create fully transmembrane tetraether lipids and 2) the incorporation of small rings into these tethered segments. We found that membranes formed from pure tetraether lipids leaked small ions at a rate that was about two orders of magnitude slower than common bilayer-forming lipids. Incorporation of cyclopentane rings into the tetraether lipids did not affect membrane leakage, whereas a cyclohexane ring reduced leakage by an additional 40 %. These results show that mimicking certain structural features of natural archaeal lipids results in improved membrane integrity, which may help overcome limitations of many current lipid-based technologies.

The passive leakage of small molecules across membranes is a major limitation of liposomal drug formulations. Here, we evaluate the leakage of 3 clinically used chemotherapeutic agents (cytarabine, methotrexate and vincristine) encapsulated in liposomes comprised of a synthetic, archaea-inspired, membrane-spanning tetraether lipid. Liposomes comprised of the pure tetraether lipid exhibited superior retention of both a neutrally and positively charged drug (up to an ∼9-fold decrease in the rate of drug leakage) compared to liposomes formed from a commercial diacyl lipid, while exhibiting a similar retention of a negatively charged drug that did not appreciably leak from either type of liposome. We also demonstrate that liposomes made of the archaea-inspired lipid can be used for the delivery of encapsulated small molecules into living cells.

In the context of sensing and characterizing single proteins with synthetic nanopores, lipid bilayer coatings provide at least four benefits: first, they minimize unwanted protein adhesion to the pore walls by exposing a zwitterionic, fluid surface. Second, they can slow down protein translocation and rotation by the opportunity to tether proteins with a lipid anchor to the fluid bilayer coating. Third, they provide the possibility to impart analyte specificity by including lipid anchors with a specific receptor or ligand in the coating. Fourth, they offer a method for tuning nanopore diameters by choice of the length of the lipid’s acyl chains. The work presented here compares four properties of various lipid compositions with regard to their suitability as nanopore coatings for protein sensing experiments: (1) electrical noise during current recordings through solid-state nanopores before and after lipid coating, (2) long-term stability of the recorded current baseline and, by inference, of the coating, (3) viscosity of the coating as quantified by the lateral diffusion coefficient of lipids in the coating, and (4) the success rate of generating a suitable coating for quantitative nanopore-based resistive pulse recordings. We surveyed lipid coatings prepared from bolaamphiphilic, monolayer-forming lipids inspired by extremophile archaea and compared them to typical bilayer-forming phosphatidylcholine lipids containing various fractions of curvature-inducing lipids or cholesterol. We found that coatings from archaea-inspired lipids provide several advantages compared to conventional phospholipids; the stable, low noise baseline qualities and high viscosity make these membranes especially suitable for analysis that estimates physical protein parameters such as the net charge of proteins as they enable translocation events with sufficiently long duration to time-resolve dwell time distributions completely. The work presented here reveals that the ease or difficulty of coating a nanopore with lipid membranes did not depend significantly on the composition of the lipid mixture, but rather on the geometry and surface chemistry of the nanopore in the solid state substrate. In particular, annealing substrates containing the nanopore increased the success rate of generating stable lipid coatings.