Atmospheric black carbon (BC) warms Earth's climate, and its reduction has been targeted for near-term climate change mitigation. Models that include forcing by BC assume internal mixing with non-BC aerosol components that enhance BC absorption, often by a factor of ~2; such model estimates have yet to be clearly validated through atmospheric observations. Here, direct in situ measurements of BC absorption enhancements (E(abs)) and mixing state are reported for two California regions. The observed E(abs) is small-6% on average at 532 nm-and increases weakly with photochemical aging. The E(abs) is less than predicted from observationally constrained theoretical calculations, suggesting that many climate models may overestimate warming by BC. These ambient observations stand in contrast to laboratory measurements that show substantial E(abs) for BC are possible.

Abstract. The Mexico City Metropolitan Area (MCMA) study in April 2003 had measurements of many atmospheric constituents, including OH and HO 2 . It provided the first opportunity to examine atmospheric oxidation in a megacity in a developing country that has more pollution than typical U.S. and European cities. At midday, OH typically reached 0.35 pptv (∼7×10 6 cm −3 ), comparable to amounts observed in U.S. cities, but HO 2 reached 40 pptv, more than observed in most U.S. cities. The OH reactivity was also measured, even during the highly polluted morning rush hour. MCMA's OH reactivity was 25 s −1 during most of the day and 120 s −1 at morning rush hour, which was several times greater than has been measured in any U.S. city. Median measured and modeled OH and HO 2 agreed to within combined uncertainties, although for OH, the model exceeded the measurement by more than 30% during midday. OH production and loss, which were calculated from measurements, were in balance to within uncertainties, although production exceeded loss during morning rush hour. This imbalance has been observed in other cities. The HO 2 /OH ratio from measurements and steady-state analyses have essentially the same dependence on NO, except when NO was near 100 ppbv. This agreement is unlike other urban studies, in which HO 2 /OH ratio decreased much less than expected as NO increased. As a result of the active photochemistry in MCMA 2003, the median calculated ozone production from measured HO 2 reached 50 ppb h −1 , a much higher rate than observed in U.S. cities.

Emissions of volatile chemicals control the hydroxyl radical (OH), the atmosphere's main cleansing agent, and thus the production of secondary pollutants. Accounting for all of these chemicals can be difficult, especially in environments with mixed urban and forest emissions. The first direct measurements of the atmospheric OH reactivity, the inverse of the OH lifetime, were made as part of the Southern Oxidant Study (SOS) at Cornelia Fort Airpark in Nashville, TN in summer 1999. Measured OH reactivity was typically 11 s(-1). Measured OH reactivity was 1.4 times larger than OH reactivity calculated from the sum of the products of measured chemical concentrations and their OH reaction rate coefficients. This difference is statistically significant at the 1sigma uncertainty level of both the measurements and the calculations but not the 2sigma uncertainty level. Measured OH reactivity was 1.3 times larger than the OH reactivity from a model that uses measured ambient concentrations of volatile organic compounds (VOCs), NO, NO2, SO2, and CO. However, it was within approximately 10% of the OH reactivity from a model that includes hydrocarbon measurements made in a Nashville tunnel and scaled to the ambient CO at Cornelia Fort Airpark. These comparisons indicate that 30% of the OH reactivity in Nashville may come from short-lived highly reactive VOCs that are not usually measured in field intensive studies or by US EPA's Photochemical Assessment Monitoring Stations.

Abstract. Hydroxyl (OH) and hydroperoxyl (HO2) radicals are key species driving the oxidation of volatile organic compounds that can lead to the production of ozone and secondary organic aerosols. Previous measurements of these radicals in forest environments with high isoprene, low NOx conditions have shown serious discrepancies with modeled concentrations, bringing into question the current understanding of isoprene oxidation chemistry in these environments. During the summers of 2008 and 2009, OH and peroxy radical concentrations were measured using a laser-induced fluorescence instrument as part of the PROPHET (Program for Research on Oxidants: PHotochemistry, Emissions, and Transport) and CABINEX (Community Atmosphere-Biosphere INteractions EXperiment) campaigns at a forested site in northern Michigan. Supporting measurements of photolysis rates, volatile organic compounds, NOx (NO + NO2 and other inorganic species were used to constrain a zero-dimensional box model based on the Regional Atmospheric Chemistry Mechanism, modified to include the Mainz Isoprene Mechanism (RACM-MIM). The CABINEX model OH predictions were in good agreement with the measured OH concentrations, with an observed-to-modeled ratio near one (0.70 ± 0.31) for isoprene mixing ratios between 1–2 ppb on average. The measured peroxy radical concentrations, reflecting the sum of HO2 and isoprene-based peroxy radicals, were generally lower than predicted by the box model in both years.

Proton‐transfer‐reaction mass spectrometry (PTR‐MS) was deployed for continuous real‐time monitoring of volatile organic compounds (VOCs) at a site near the Houston Ship Channel during the Texas Air Quality Study 2000. Overall, 28 ions dominated the PTR‐MS mass spectra and were assigned as anthropogenic aromatics (e.g., benzene, toluene, xylenes) and hydrocarbons (propene, isoprene), oxygenated compounds (e.g., formaldehyde, acetaldehyde, acetone, methanol, C7 carbonyls), and three nitrogen‐containing compounds (e.g., HCN, acetonitrile and acrylonitrile). Biogenic VOCs were minor components at this site. Propene was the most abundant lightweight hydrocarbon detected by this technique with concentrations up to 100+ nmol mol−1, and was highly correlated with its oxidation products, formaldehyde (up to ∼40 nmol mol−1) and acetaldehyde (up to ∼80 nmol/mol), with typical ratios close to 1 in propene‐dominated plumes. In the case of aromatic species the high time resolution of the obtained data set helped in identifying different anthropogenic sources (e.g., industrial from urban emissions) and testing current emission inventories. A comparison with results from complimentary techniques (gas chromatography, differential optical absorption spectroscopy) was used to assess the selectivity of this on‐line technique in a complex urban and industrial VOC matrix and give an interpretation of mass scans obtained by “soft” chemical ionization using proton‐transfer via H3O+. The method was especially valuable in monitoring rapidly changing VOC plumes which passed over the site, and when coupled with meteorological data it was possible to identify likely sources.