Textured bismuth titanate, Bi 4 Ti 3 O 12 (BiT), was produced by templated grain growth (TGG). Molten-salt-synthesized BiT platelets were dispersed in a matrix of 200 nm BiT powder and aligned by tape casting. Highly textured BiT was obtained with the use of only 5 vol% template particles by sintering at 1000°C for 1 h. The uniformity of the through-thickness texture is much higher than reported in the literature for BiT tapes cast with 100% platelets. Initial platelet alignment is shown to increase because of frequent interaction with the fine powder particles during tape casting. By avoiding pressure densification techniques and using only a small portion of anisometric particles, TGG is a low-cost option for fabricating textured ceramics.

No abstract

Ferroelectric materials are well‐suited for a variety of applications because they can offer a combination of high performance and scaled integration. Examples of note include piezoelectrics to transform between electrical and mechanical energies, capacitors used to store charge, electro‐optic devices, and nonvolatile memory storage. Accordingly, they are widely used as sensors, actuators, energy storage, and memory components, ultrasonic devices, and in consumer electronics products. Because these functional properties arise from a noncentrosymmetric crystal structure with spontaneous strain and a permanent electric dipole, the properties depend upon physical and electrical boundary conditions, and consequently, physical dimension. The change in properties with decreasing physical dimension is commonly referred to as a size effect. In thin films, size effects are widely observed, whereas in bulk ceramics, changes in properties from the values of large‐grained specimens is most notable in samples with grain sizes below several micrometers. It is important to note that ferroelectricity typically persists to length scales of about 10 nm, but below this point is often absent. Despite the stability of ferroelectricity for dimensions greater than ~10 nm, the dielectric and piezoelectric coefficients of scaled ferroelectrics are suppressed relative to their bulk counterparts, in some cases by changes up to 80%. The loss of extrinsic contributions (domain and phase boundary motion) to the electromechanical response accounts for much of this suppression. In this article, the current understanding of the underlying mechanisms for this behavior in perovskite ferroelectrics is reviewed. We focus on the intrinsic limits of ferroelectric response, the roles of electrical and mechanical boundary conditions, grain size and thickness effects, and extraneous effects related to processing. In many cases, multiple mechanisms combine to produce the observed scaling effects.

Piezoelectric materials convert between electrical and mechanical energies such that an applied stress induces a polarization and an applied electric field induces a strain. This review describes the fundamental mechanisms governing the piezoelectric response in high-performance piezoelectric single crystals, ceramics, and thin films. While there are a number of useful piezoelectric small molecules and polymers, the article focuses on inorganic materials displaying the piezoelectric effect. Piezoelectricity is first defined, and the mechanisms that contribute are discussed in terms of the key crystal structures for materials with large piezoelectric coefficients. Exemplar systems are then discussed and compared for the cases of single crystals, bulk ceramics, and thin films.