Most atmospheric motions of different spatial scales and precipitation are closely related to phase transitions in clouds. The continuously increasing resolution of large-scale and mesoscale atmospheric models makes it feasible to treat the evolution of individual clouds. The explicit treatment of clouds requires the simulation of cloud microphysics. Two main approaches describing cloud microphysical properties and processes have been developed in the past four and a half decades: bulk microphysics parameterization and spectral (bin) microphysics (SBM). The development and utilization of both represent an important step forward in cloud modeling. This study presents a detailed survey of the physical basis and the applications of both bulk microphysics parameterization and SBM. The results obtained from simulations of a wide range of atmospheric phenomena, from tropical cyclones through Arctic clouds using these two approaches are compared. Advantages and disadvantages, as well as lines of future development for these methods are discussed.

Toward the end of the Cirrus Regional Study of Tropical Anvils and Cirrus Layer-Florida Area Cirrus Experiment (CRYSTAL-FACE) field campaign held during July 2002, high concentrations of Saharan dust, which can serve as cloud condensation nuclei (CCN), giant CCN (GCCN), and ice-forming nuclei (IFN) were observed over the peninsula of Florida. To investigate the impacts of enhanced aerosol concentrations on the characteristics of convective storms and their subsequent anvil development, sensitivity tests are conducted using the Regional Atmospheric Modeling System (RAMS) model, in which the initialization profiles of CCN, GCCN, and IFN concentrations are varied. These variations are found to have significant effects on the storm dynamics and microphysical processes, as well as on the surface precipitation. Updrafts are consistently stronger as the aerosol concentrations are increased. The anvils cover a smaller area but are better organized and have larger condensate mixing ratio maxima in the cases with greater aerosol concentrations. Cloud water mass tends to increase with increasing aerosol concentrations, with enhanced GCCN concentrations having the most significant influence. Increasing either the GCCN or IFN concentrations produces the most rainfall at the surface whereas enhanced CCN concentrations reduce surface rainfall. Higher IFN concentrations produce ice at warmer temperatures and deeper anvils, but simultaneously increasing the concentrations of CCN and GCCN leads to more supercooled liquid water available for freezing and greater ice mixing ratios. Graupel mixing ratios decrease and hail mixing ratios increase with increasing aerosol concentrations. Higher concentrations of GCCN and IFN result in greater accumulated surface precipitation initially. By the end of the simulation period, however, the accumulated precipitation is the greatest for the case in which the aerosol concentrations are lowest. Such changes in the dynamical and microphysical characteristics of convective storms as a result of the variations in aerosol concentrations have potential climate consequences, both through cloud radiative effects and the hydrological cycle. The impacts of varying CCN, GCCN, and IFN concentrations on the anvils will be discussed more fully in Part II.

Aerosols are known to have both direct and indirect effects on clouds through their role as cloud condensation nuclei. This study examines the effects of differing aerosol concentrations on convective storms developing under different environments. The Regional Atmospheric Modeling System (RAMS), a cloud-resolving model with sophisticated microphysical and aerosol parameterization schemes, was used to achieve the goals of this study. A sounding that would produce deep convection was chosen and consistently modified to obtain a variety of CAPE values. Additionally, the model was initiated with varying concentrations of aerosols that were available to act as cloud condensation nuclei. Each model run produced long-lived convective storms with similar storm development, but they differed slightly based on the initial conditions. Runs with higher initial CAPE values produced the strongest storms overall, with stronger updrafts and larger amounts of accumulated surface precipitation. Simulations initiated with larger concentrations of aerosols developed similar storm structures but showed some distinctive dynamical and microphysical changes because of aerosol indirect effects. Many of the changes seen because of varying aerosol concentrations were of either the same order or larger magnitude than those brought about by changing the convective environment.

The impacts of urban-enhanced aerosol concentrations on convective storm development and precipitation over and downwind of St. Louis, Missouri, are investigated. This is achieved through the use of a cloud-resolving mesoscale model, in which sophisticated land use processes and aerosol microphysics are both incorporated. The results indicate that urban-forced convergence downwind of the city, rather than the presence of greater aerosol concentrations, determines whether storms actually develop in the downwind region. Once convection is initiated, urban-enhanced aerosols can exert a significant effect on the dynamics, microphysics, and precipitation produced by these storms. The model results indicate, however, that the response to urban-enhanced aerosol depends on the background concentrations of aerosols; a weaker response occurs with increasing background aerosol concentrations. The effects of aerosols influence the rate and amount of liquid water and ice produced within these storms, the accumulated surface precipitation, the strength and timing of the updrafts and downdrafts, the longevity of the updrafts, and the strength and influence of the cold pool. Complex, nonlinear relationships and feedbacks between the microphysics and storm dynamics exist, making it difficult to make definitive statements about the effects of urbanenhanced aerosols on downwind precipitation and convection. Because the impacts of urban aerosol on downwind storms decrease with increasing background aerosol concentrations, generalization of these results depends on the unique character of background aerosol for each urban area. For urban centers in coastal areas where background aerosol concentrations may be very low, it is speculated that urban aerosol can have very large influences on convective storm dynamics, microphysics, and precipitation.

The impacts of enhanced aerosol concentrations such as those associated with dust intrusions on the trimodal distribution of tropical convection have been investigated through the use of large-domain (10 000 grid points), fine-resolution (1 km), long-duration (100 days), two-dimensional idealized cloud-resolving model simulations conducted under conditions of radiative-convective equilibrium (RCE). The focus of this research is on those aerosols that serve primarily as cloud condensation nuclei (CCN). The results demonstrate that the large-scale organization of convection, the domain-averaged precipitation, and the total cloud fraction show only show a weak response to enhanced aerosol concentrations. However, while the domainwide responses to enhanced aerosol concentrations are weak, aerosol indirect effects on the three tropical cloud modes are found to be quite significant and often opposite in sign, a fact that appears to contribute to the weaker domain response. The results suggest that aerosol indirect effects associated with shallow clouds may offset or compensate for the aerosol indirect effects associated with congestus and deep convection systems and vice versa, thus producing a more moderate domainwide response to aerosol indirect forcing. Finally, when assessing the impacts of aerosol indirect forcing associated with CCN on the characteristics of tropical convection, several aspects need to be considered, including which cloud mode or type is being investigated, the field of interest, and whether localized or systemwide responses are being examined.