Executive SummaryDynamically loaded wind turbine generator (WTG) foundation design requires a specialized design process due to abnormal loading conditions over a large bearing area.Multiple foundation options exist to support WTGs. A large octagonal mass of reinforced concrete is the most commonly used foundation type. Two high-capacity (≥ 1.5 MW) WTGs were instrumented in the upper Midwest of the US. The instrumentation was oriented to take advantage of the predominant wind direction in each site. This thesis focuses on the interpretation and analysis of data from these two instrumented WTG foundations.Ten soil deformation gauges were installed at each site. The main purpose of the soil strain gauges (SG) was to measure the deformation of the underlying bearing soil at different locations and depths. Pressure gauges (PG) were installed to monitor the dynamic pressure distribution underlying the octagonal WTG foundations. At one of the sites (Site A), thermal dissipation sensors and micro-electro-mechanical system accelerometers (MEMS) were installed to monitor volumetric water content change and foundation block rotation, respectively. Turbine towers were also instrumented with strain gauges to estimate moment transfer from the tower to the foundation. Improvement of design approaches for dynamically loaded foundations, such as WTG foundations, requires knowledge of stress-strain transfer mechanisms. Data analysis from fieldinstrumented WTG foundation systems can be used to validate present-day design assumptions and to provide new and mechanically accurate approaches. Observations of contact pressure distribution, foundation soil deformation, and transferred moment from tower to foundation assist in understanding the mechanistic and dynamic behavior of WTG foundations and soil bearing response. 3Based on this research effort, changes in soil pressure and strain were highly related to wind direction and speed. At normal operating conditions, the most variation in pressure distribution was observed towards the edge of the foundation. Normalized pressure amplitude was around 0.35 (pressure/pressure average of analyzed data set) for the pressure cells locate at the edge of the foundation. Interior pressure cells (e.g., PG-2, PG-3, and PG-4), on the other hand, exhibited lower amplitudes (≤ 0.10). This indicates that the outer portion of the foundation is more susceptible to stress changes. Although pressure was distributed across entire the foundation footprint, pressure response was not uniform.Pressure shifts were observed in the cases of startup and shutdown conditions. During the shutdown sequences, greater pressure fluctuations were observed (e.g., 17% in PG-3, 48% in PG-4). Pressure data analysis indicated that maximum and minimum pressures occur during turbine shutdown. Pressure spikes were observed during shutdown varying from 2 kPa to 10 kPa depending on the location of the pressure cell.Pressure cell -soil stiffness interaction is required for analysis of this type of field data.Under-representation was...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.