Pengelasan adalah proses menyambungkan dua logam atau lebih dengan cara melelehkan logam induk menggunakan energi panas. Penelitan ini bertujuan untuk mengetahui nilai kekuatan uji bending pada pengelasan SMAW menggunakan kawat las E6013 dengan berbagai variasi arus listrik, yaitu 80A, 90A dan 100A. Metode pengelasan yang digunakan adalah las SMAW dengan material SS400. Jenis kampuh yang digunakan adalah kampuh V dengan kemiringan 60° standarisasi AWS d1.1:2000. Pengujian yang dilakukan adalah pengujian bending dengan metode Three Point Bending. Spesimen uji bending berdasarkan standarisasi ASTM E23-02. Nilai kekuatan uji bending paling rendah adalah pada kuat arus 80A dengan nilai rata-rata tegangan bending sebesar 1,256 N/mm². Nilai rata-rata kekuatan uji bending untuk kuat arus 90A rata - rata tegangan bending sebesar 1,305 N/mm².Untuk kuat arus 100A adalah yang terbesar yaitu sebesar 1,387 N/mm².
Salah satu sumber bahan bakar nabati yang berpotensi misalnya adalah buah berenuk (crescentia cujete L.), karena mempunyai kandungan karbohidrat yang cukup tinggi yaitu 15,56% (wet basis) dan 68,13% (dry basis). Bioetanol cair dapat diubah menjadi gel dengan penambahan pengental yang mempunyai nilai ekonomis, misalnya carboxymethyl cellulose (CMC). Penelitian ini bertujuan untuk mengetahui sifat-sifat pembakaran gel etanol dari buah berenuk (crescentia cujete L.) menggunakan bahan pengental CMC yang dihasilkan, seperti: nilai kalor, dan uji pembakaran (laju pembakaran, nyala api dan residu hasil pembakaran), sehingga dapat diketahui formulasi terbaik untuk menghasilkan gel etanol. Pembuatan gel bioetanol dilakukan proses gelasi yaitu dengan mencampurkan bahan pengental CMC sebanyak 1, 2, dan 3 gram dengan 20 mL akuades, dan bioetanol cair sebanyak 100 g sedikit demi sedikit dengan pengadukan menggunakan magnetic stirrer selama 15 menit dengan kecepatan 600 rpm. Hasil penelitian menunjukkan bahwa sifat-sifat pembakaran terbaik adalah pada variasi berat (CMC) sebesar 3 gram dengan nilai kalor sebesar 2.334 kal/ gram, laju pembakaran 0,0369 gram/ detik dan residu pembakaran berkisar antara 45-47%.
Masin merupakan salah satu makanan tradisional Sumbawa yang berbahan baku udang rebon. Salah satu cara meningkatkan produktifitas pembuatan masin adalah mengoptimalkan proses fermentasi dengan mempertahankan temperatur fermentasi selama proses produksi pada suhu optimal. Pada penelitian ini akan dilakukan karakterisasi bioreaktor masin dengan kontrol suhu otomatis. Bioreaktor dirancang berbentuk kubus dengan ukuran 50 cm x 50 cm x 50 cm yang dilengkapi dengan pemanas dan pengontrol suhu menggunakan Arduino. Setelah itu, setting point bioreaktor diatur pada suhu 37 o C. Proses selanjutnya adalah pengujian kadar air, kadar protein, kadar lemak dan jumlah mikroba dari sampel pada hari ketiga dan ketujuh fermentasi, kemudian dibandingkan antara produk masin menggunakan bioreaktor dengan masin yang diproduksi secara tradisional. Hasil penelitian ini memperlihatkan nilai rata-rata suhu reaktor pada hari ketiga adalah 37,27 o C, sedangakan pada hari ketujuh suhu rata-rata bioreaktor sebesar 37,14°C. Kadar air dan kadar lemak tertinggi didapatkan pada sampel yang menggunakan bioreaktor pada hari ketujuh yaitu 62,36% dan 2,44%. Kadar protein tertinggi didapatkan pada sampel yang menggunakan bioreaktor pada hari ketiga yaitu 12,32%. Jumlah mikroba terendah diperoleh pada sampel yang menggunakan bioreaktor pada hari ketujuh yaitu 13x10 4 . Hasil penelitian ini menunjukkan bahwa biorektor masin yang dirancang dapat mempercepat proses pembuatan masin.
The Sembelia Steam Power Plant is located in East Lombok, West Nusa Tenggara and is managed by PT. Lombok Energy Dynamic uses the light coal until 200,000 tons per year. This case can be the environmental pollution. This study aims to calculate the SO2 and CO2 exhaust gases into the environment by the simulation as well as included the fatality percentage due to coal combustion of the The Sembelia Steam Power Plant with the model of Gaussian. This research was carried out by calculating the SO2 and CO2concentrations released concentration. At the end of these project, we calculated the SO2 and CO2 released by the dispersion potential and fatality percentage at four points around it. The result of this research showed that the dispersion mass of SO2 dispersion was 0.096 kg per second (with distance of 2,000 to 46,000 m). This result showed that the increases (6.876x10-46 ppm to 1.276x10-5 ppm), and then showed that the decreases to 0 ppm. Fatality percentage in this study is 0 percent. The potential of CO2 dispersion with an outgoing mass of 8,252 kg/second increased (2,000-58,000 m) with a concentration of 62.47x10-63 ppm to 7.9x10-4ppm. In the other hand, the concentration of CO2 was reduced to 0 ppm. In the end of this study showed that fatality percentage by the CO2 released is 0percent, and the calculation of dispersion at four points around the The Sembelia Steam Power Plant is safe from the SO2 and CO2dispersion.
Household energy need in Indonesia, especially for cooking, are still dominated by LPG fossil fuels with 70% of LPG needs being imported. On the other hand, the availability of biomass waste, especially candlenut shells, is abundant. One way to optimize the use of candlenut shells is to use candlenut shells as fuel for biomass stoves by optimizing the efficiency of biomass stoves. In this study, a biomass stove with primary and secondary airflow was used with a combustion chamber diameter of 200 mm and a height of 340 mm. The biomass waste used is candlenut shells as fuel. The purpose of this study was to explain the increase in the performance of a biomass stove fueled with candlenut shell which is influenced by primary and secondary air velocity. Biomass stove testing includes thermal efficiency, specific fuel consumption, CO and CO2 emissions. The performance test results show that the biomass stove with a primary air velocity of 3.7 m/s, a secondary air velocity of 3.7 m/s has the highest thermal efficiency of 45.77%. The lowest specific fuel consumption is obtained from a biomass stove with a primary air velocity of 1.5 m/s, a secondary air velocity of 1.5 m/s, which is 0.583 kg/hour, and the emission test results show that complete combustion occurs with 0% CO emotion. on all air velocity variables studied.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.