Unique worm-like BiVO4 nanoparticles prepared through hydrothermal treatment of scheelite tetragonal BiVO4 show enhanced performance towards photo-electrochemical water splitting.

Gallium nitride (GaN) film delamination is an important process during the fabrication of GaN light-emitting diodes (LEDs) and laser diodes. Here, we utilize 520 nm femtosecond laser pulses, exploiting nonlinear absorption rather than single-photon absorption such as in conventional laser lift-off (LLO) employing excimer or Q-switched laser sources. The focus of this study is to investigate the influence of laser scanning speed and integrated fluence corresponding to laser energy per area during the LLO processing of GaN LED chips and their resulting structural properties. Because both the sapphire substrate and InGaN/GaN heterostructures are fully transparent to the emission of the laser system, a key question is related to the impact of laser pulses on the quality of a thin film structure. Therefore, several characterization methods (i.e., scanning electron microscopy, atomic force microscopy, X-ray diffraction, Raman spectroscopy, and electroluminescence spectroscopy) were employed to understand the material modifications made by femtosecond LLO (fs-LLO). We demonstrated that by adjusting the laser scanning speed, smooth GaN surfaces and good crystal quality could be obtained regardless of the existing delamination of metal contact, which then slightly downgraded the LED performance. Here, the integrated fluence level was set in the range of 2.6–4.4 J/cm2 to enable the fs-LLO process. Moreover, two mitigation strategies were developed and proven to improve the optoelectrical characteristics of the lifted-off LEDs (i.e., modification of the processing step related to the metal creation and reduction of laser energy).

The electrocatalytic water splitting activity of layered transition metal dichalcogenides (TMDs) is limited by inert basal planes and slower reaction kinetics. Here, we demonstrate the use of MoSe2–Cu2S nanoheterostructures (NHSs)...

The Burstein–Moss suggests which that the optical band gap of degenerately doped semiconductors increases when all states close to the conduction band get populated is important to obtain different optical properties for the same material.