A continuous tubular crystallizer system with an inner diameter of 2.0 mm and an overall length of 27 m was used to generate acetylsalicylic acid seeds in situ from ethanolic solution via cooling and ultrasound irradiation and to grow the crystals in the tubing with a controlled temperature trajectory. In order to minimize the residence time distribution, air bubbles were introduced into the system to generate a segmented gas-slurry flow. The narrow residence time distribution and the tight temperature control in the small tubing due to the large surface to volume ratio resulted in relatively narrow crystal size distributions of the product. Generally, all experiments clearly demonstrated significant crystal growth for the product crystals in comparison to the seeds and yielded product masses on the g/min scale. Furthermore, it was demonstrated that the size of the product can be easily controlled via fines removal by dissolution due to rapid heating and varying the mass of seeds per mL of solution.

Abstract. Pellets intended for oral dosing are frequently produced via extrusion/spheronization followed by drying. Typically, the last active process step, i.e., drying, is assumed to have little effect on the final dosage form properties (e.g., dissolution characteristics). Thus, there exist only a few studies of this subject. In the present study, calcium stearate/ibuprofen pellets were used as model system to investigate the impact of the drying conditions. Lipophilic calcium stearate matrix pellets containing 20% ibuprofen were prepared via wet extrusion/spheronization. Subsequently, desiccation, fluid-bed drying, and lyophilization were applied for granulation liquid removal. The impact of these drying techniques on the final pellet properties was evaluated. The in vitro dissolution behavior was dramatically altered by the drying techniques that were considered. The investigated pellets showed drug release rates that varied as much as 100%. As no polymorphic transitions occurred during drying, we focused on two possible explanations: (a) a change in the drug distribution within the pellets and (b) a change in pellet micro-structure (porosity, pore size). The ibuprofen distribution proved to be homogeneous regardless of the drying conditions. Pellet porosity and pore sizes, however, were modified by the drying process. Our results clearly demonstrate that a single process step, such as drying, can play a crucial role in achieving desired pellet properties and release profiles.

No abstract