Cellulose nanofibrils can be obtained from trees and have considerable potential as a building block for biobased materials. In order to achieve good properties of these materials, the nanostructure must be controlled. Here we present a process combining hydrodynamic alignment with a dispersion–gel transition that produces homogeneous and smooth filaments from a low-concentration dispersion of cellulose nanofibrils in water. The preferential fibril orientation along the filament direction can be controlled by the process parameters. The specific ultimate strength is considerably higher than previously reported filaments made of cellulose nanofibrils. The strength is even in line with the strongest cellulose pulp fibres extracted from wood with the same degree of fibril alignment. Successful nanoscale alignment before gelation demands a proper separation of the timescales involved. Somewhat surprisingly, the device must not be too small if this is to be achieved.

Optically transparent wood (TW) with transmittance as high as 85% and haze of 71% was obtained using a delignified nanoporous wood template. The template was prepared by removing the light-absorbing lignin component, creating nanoporosity in the wood cell wall. Transparent wood was prepared by successful impregnation of lumen and the nanoscale cellulose fiber network in the cell wall with refractive-index-matched prepolymerized methyl methacrylate (MMA). During the process, the hierarchical wood structure was preserved. Optical properties of TW are tunable by changing the cellulose volume fraction. The synergy between wood and PMMA was observed for mechanical properties. Lightweight and strong transparent wood is a potential candidate for lightweight low-cost, light-transmitting buildings and transparent solar cell windows.

The fabrication of substrates for Surface Enhanced Raman Scattering (SERS) applications matching the needs for high sensitive and reproducible sensors remains a major scientific and technological issue. We correlate the morphological parameters of silver (Ag) nanostructured thin films prepared by sputter deposition on flat silicon (Si) substrates with their SERS activity. A maximum enhancement of the SERS signal has been found at the Ag percolation threshold, leading to the detection of thiophenol, a non-resonant Raman probe, at concentrations as low as 10−10M, which corresponds to enhancement factors higher than 7 orders of magnitude. To gain full control over the developed nanostructure, we employed the combination of in-situ time-resolved microfocus Grazing Incidence Small Angle X-ray Scattering with sputter deposition. This enables to achieve a deepened understanding of the different growth regimes of Ag. Thereby an improved tailoring of the thin film nanostructure for SERS applications can be realized.

We present a comprehensive study of the interaction of human serum albumin (HSA) with poly(acrylic acid) (PAA; number average degree of polymerization: 25) in aqueous solution. The interaction of HSA with PAA is studied in dilute solution as a function of the concentration of added salt (20-100 mM) and temperature (25-37 °C). Isothermal titration calorimetry (ITC) is used to analyze the interaction and to determine the binding constant and related thermodynamic data. It is found that only one PAA chain is bound per HSA molecule. The free energy of binding ΔGb increases with temperature significantly. ΔGb decreases with increasing salt concentration and is dominated by entropic contributions due to the release of bound counterions. Coarse-grained Langevin computer simulations treating the counterions in an explicit manner are used to study the process of binding in detail. These simulations demonstrate that the PAA chains are bound in the Sudlow II site of HSA. Moreover, ΔGb is calculated from the simulations and found to be in very good agreement with the measured data. The simulations demonstrate clearly that the driving force of binding is the release of counterions in full agreement with the ITC-data.