Drying of faecal sludge enclosed in a breathable, hydrophobic membrane laminate was investigated for the potential application of breathable membranes in decentralized container-based sanitation systems for developing nations. Moisture loss from the membrane-enclosed faecal sludge was studied using membrane ‘envelopes’ filled with faecal sludge collected from random volunteers. A drying test with a new membrane envelope resulted in 71.2% mass reduction over a period of 7 days with an average moisture flux of 0.73 g/day-cm2. Slight decrease in the sludge drying rates was observed over five reuses of the same membrane envelope. A stagnant film model was used to predict drying rates of membrane-enclosed faecal sludge in ten developing countries with high urban populations. Based on a loading rate of 15 L/day into a 200-L (55-gallon) collection container, the predicted drying rates range from 7.1 to 12.4 L/day. The filling time of the membrane-lined container decreased due to in-situ drying, resulting in longer operation time and less frequent emptying of the container.
Laminated hydrophobic membranes have been proposed as liners for container-based sanitation systems in developing countries. The laminate allows drying of fecal sludge, which might significantly reduce the frequency of container emptying, while containing liquids and solids. While previous laboratory tests demonstrated rapid drying of fecal sludge or water retained in laminates, experiments did not assess the effects of system dimension or scale on performance. In this study fecal sludge drying and water evaporation were evaluated in 3D laminate boxes (decimeter scale) or 3D laminate-lined 40 L and 55 gallon drums (meter scale) that are prototypes of toilet containers for field application. A stagnant film model described fecal sludge drying and water evaporation in the laminate boxes and laminate-lined drums well. The effective diffusion length ( λ ) for the laminate was fitted in all systems and increased with system dimension and scale: λ increased by a factor of 1.4 from 1D decimeter-scale envelopes to 3D decimeter-scale boxes, and by a factor of 1.3–1.7 from 3D decimeter-scale boxes to 3D meter-scale drums. The longer λ with increasing dimension and scale is likely due to nonuniform temperature and relative humidity in the air outside the laminate and nonuniform temperature within the laminate. Using best-fit λ for the laminate-lined 40 L and 55 gallon drum experiments conducted in a controlled laboratory, drying was predicted for an 11-day field experiment. Although the air temperature and relative humidity varied significantly in the field tests from −1 °C to 26 °C and 35% to 97%, respectively, the stagnant film model predicted drying over the 11-day period reasonably well with total error ≤ 13% using 24-h average air temperature and relative humidity. Drying of fecal sludge in laminate-lined drums in the field might be adequately described with a stagnant film model using daily-average weather conditions, if wind speeds are low.
On-site sanitation systems such as pit latrines are extensively used around the world, while there is a growing number of evidence documenting the impact of pit latrines on groundwater quality that may affect human health. Hence, this paper summarizes the various safe-sanitation technologies by broadly categorizing them into fecal pathogen disinfection methods (anaerobic digestion, chemical disinfection, biological additives, solar pasteurization and vermicomposting) and capturing methods (pit lining and permeable reactive barriers, the latter of which simultaneously capture and sanitize fecal sludge in pit latrines). While some of the reviewed technologies have been widely practiced for mitigating microbial contamination of the groundwater, others are still in the early stage of commercialization and field validation. Though there are challenges to the selection and adoption of the most appropriate technology, this paper discusses the readiness of each technology as a stand-alone fecal sludge management solution.
Drying of fecal sludge (FS) enclosed in a breathable, hydrophobic membrane laminate was investigated in 208 and 40 L container-based toilet (CBS) systems referred to as Eco-Vapor toilets (EVTs). EVTs were constructed and pilot tested in four households in urban slums of Kanpur, India over a period of 2 years. The average moisture losses of 0.8 and 0.9 kg/day were observed in laminate-lined 208 L drums for Year 1 tests, and this in situ drying decreases disposal frequency by 8 days compared with CBS that do not allow FS drying. In Year 2, smaller EVTs with 40 L laminate-lined drums and waste segregation increased replacement time over conventional CBS by 45%, as opposed to the 19% increase observed in Year 1 tests. Despite its limitations, the stagnant film model using meteorological data predicted the mass-loss rate within 52 and 28% error for the 208 and 40 L drums, respectively.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.