This paper describes the design, fabrication and characterization of a complementary metal-oxide-semiconductor (CMOS) micro-electro-mechanical-system (MEMS) accelerometer implemented in a 0.18 μm multi-project wafer (MPW) CMOS MEMS process. In addition to the standard CMOS process, an additional aluminum layer and a thick photoresist masking layer are employed to achieve etching and microstructural release. The structural thickness of the accelerometer is up to 9 μm and the minimum structural spacing is 2.3 μm. The out-of-plane deflection resulted from the vertical stress gradient over the whole device is controlled to be under 0.2 μm. The chip area containing the micromechanical structure and switched-capacitor sensing circuit is 1.18 × 0.9 mm 2 , and the total power consumption is only 0.7 mW. Within the sensing range of ± 6 G, the measured nonlinearity is 1.07% and the cross-axis sensitivities with respect to the in-plane and out-of-plane are 0.5% and 5.8%, respectively. The average sensitivity of five tested accelerometers is 191.4 mV G −1 with a standard deviation of 2.5 mV G −1 . The measured output noise floor is 354 μG Hz −1/2 , corresponding to a 100 Hz 1 G sinusoidal acceleration. The measured output offset voltage is about 100 mV at 27 • C, and the zero-G temperature coefficient of the accelerometer output is 0.94 mV • C −1 below 85 • C.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.