A bananeira é uma das fruteiras de maior importância econômica, explorada quase exclusivamente por pequenos produtores. Constitui-se em fonte contínua de alimento e renda. Embora o Brasil figure como um dos maiores produtores de banana, a bananicultura nacional enfrenta sérios problemas nas fases de produção e pós-colheita, que limitam sua inserção no merca-do internacional. Um dos fatores que levam a grandes perdas na produção é o tombamento resultante da altura elevada da planta das principais cultivares comerciais. Uma estratégia para a solução deste problema é a redução do porte por indução de mutação. O objetivo deste trabalho foi caracterizar mutantes de banana tipo Prata (cv´s Pacovan e Preciosa) irradiadas, durante dois ciclos de produção, visando à seleção de plantas com porte baixo e boas características agronômicas. Plantas in vitro das duas cultivares foram irradiadas com raios gamas nas doses de 20 Gy ('Pacovan'-200 mudas) e 30 Gy ('Pre-ciosa'-200 mudas), subcultivadas por quatro vezes e posteriormente avaliadas em campo durante dois ciclos de produção. Foram selecionados quatro mutantes de cada cultivar com altura inferior à média de altura das testemunhas, após dois ciclos de avaliação. Observou-se que em alguns desses mutantes houve maior precocidade e maior massa do cacho quando comparados com as testemunhas. Pelos resultados, é possível selecionar plantas mutantes com características agronômicas superiores, tanto para a 'Pacovan' quanto para a 'Preciosa', submetidas à radiação gama. Palavras-chave: Musa spp., mutagênese in vitro, seleção de mutantes. Agronomic characterization of banana mutants obtained by gamma radiation Abstract Banana is one of the most economically important fruit, explored almost exclusively by small producers as a continuous source of food and income. Although Brazil is one of the main banana producers, the national banana production is undergoing serious problems especially in the phases of production and post-harvest limiting its participation in the international market. One of the main factors leading to great production losses is the toppling over due to the tall height of plants of main commercial cultivars. A strategy to solve this problem is reducing height by inducing mutation. The objective of the present work was to characterize irradiated Prata type banana mutants (cvs. Pacovan and Preciosa) during two production cycles in order to select short plants in height with good agronomic characteristics. In vitro plants of both cultivars were irradiated with gamma rays in the doses of 20 Gy (´Pacovan´, 200 plants) and 30 Gy (´Preciosa´, 200 plants) subcultivated four times and afterwards evaluated in the field during two production cycles. Four possible mutants were selected from each cultivar with height smaller than the average height of the controls after two evaluation cycles. It was observed that some of these mutants presented greater precocity and bunch weight compared to the controls. From the results obtained it is possible to select mutant plants with super...
RESUMO -Tensões de crescimento representam um fator limitante para o uso do eucalipto de rápido crescimento como produtor de toras para serrar. A quantificação e qualificação dessas tensões em árvores de Eucaliptos ainda carecem de muitas informações no Brasil. Assim, objetivou-se avaliar a aplicação de um novo instrumento, o extensômetro CIRAD-Forêt, na medição das deformações residuais longitudinais (DRL) em árvores de cinco materiais genéticos de Eucaliptos e correlacioná-las com outras características da madeira e dimensões das árvores. Dos resultados pôde-se concluir que: i) o extensômetro é simples de ser usado, rápido e confiável para medir e identificar árvores com diferentes níveis de tensões de crescimento; ii) a deformação residual longitudinal (DRL), associada às tensões de crescimento, medida com o extensômetro foi em média igual a 71 µm; iii) não foi encontrada diferença estatística nas DRLs medidas nas diferentes orientações cardeais em volta do tronco; iv) as DRLs variaram em função dos materiais genéticos de acordo com a análise de variância; v) em um dos materiais genéticos, no qual a DRL foi medida em duas posições ao longo do tronco (1,3 e 2,5 m), os valores foram semelhantes; vi) entre as várias propriedades da madeira, apenas a densidade básica foi correlacionada significativa e positivamente com a DRL quando todos os materiais genéticos foram analisados conjuntamente; vii) exceto para o fator de estabilidade (DAP/altura total) da progênie 5, as correlações entre as DRLs e as características de crescimento das árvores não foram significativas quando os materiais genéticos foram analisados isoladamente. Entretanto, quando os cinco materiais genéticos foram reunidos, apenas a altura total da árvore não resultou em correlação significativa com DRL; viii) a adição de DRL às características de crescimento das árvores permitiu que a densidade e as várias propriedades mecânicas da madeira fossem significativamente estimadas por modelos múltiplos.Palavras-chave: Madeira, eucalipto e tensão de crescimento. LONGITUDINAL RESIDUAL STRAINS RESULTED FROM GROWTH STRESSES IN EUCALYPTS AND THEIR ASSOCIATION WITH OTHER PROPERTIES ABSTRACT -Growth stresses are a limiting factor in the use of fast growing eucalypts for the production of sawing logs. Further studies are needed for the qualification and mensuration of these stresses in eucalypts trees in
RESUMO -Os objetivos do presente estudo foram classificar e selecionar genótipos superiores de eucalipto por meio das propriedades de sua madeira, utilizando como ferramenta a análise de agrupamento, método de otimização de Tocher, com o intuito de obter múltiplos produtos. Foram utilizados 44 genótipos de eucaliptos, adaptados para as condições ambientais do noroeste de Minas Gerais. Para classificação dos materiais foram utilizadas características físicas, de resistência mecânica e químicas da madeira. Os resultados da análise de agrupamento classificaram os 44 genótipos em 11 grupos distintos, com alta variabilidade ou divergência entre si. De acordo com os valores médios das características apresentadas pelos grupos formados, foi possível definir novos clones de potencial, que certamente forneceram madeira de qualidade superior para atender a diversos usos. Os genótipos pertencentes aos grupos V, VI e VIII apresentam potencial favorável à produção de madeira serrada. Eles possibilitarão, também, a geração de híbridos artificiais a serem usados em futuros programas de melhoramento genético de Eucalyptus.Palavras-chave: Propriedades da madeira, melhoramento florestal, Eucalyptus e análise de agrupamento. PROPERTIES AND CLASSIFICATION OF WOOD FOR SELECTING Eucalyptus GENOTYPES ABSTRACT -The objective of this study was to classify and select superior genotypes of eucalypt based on the properties of its wood, utilizing cluster analysis, the Tocher's optimization method aiming to obtain various products. Forty-four genotypes adapted to the environmental conditions of northwestern Minas
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.