The field of separations science will be strongly impacted by new electric-field-gradient-based strategies. Many new capabilities are being developed with analytical targets ranging from particles to small molecules, and soot to living cells. Here we review the emerging area of electric field gradient techniques, dividing the large variety of techniques by the target of separation. In doing so, we have contributions using dielectrophoresis, electric field gradient focusing (including dynamic, true moving bed, and pulsed field), electrocapture and electrophoretic focusing, temperature gradient focusing, and focusing with centrifugal force. We cover the literature from the start of 2007 to June 2008, along with some introductory discussions. Even with the relatively short time frame, this young and dynamic field of inquiry produced some 100 contributions describing new and unique techniques and several new applications.

Insulator-based dielectrophoretic separation of small particles in a sawtooth channel is studied in the limit of dilute concentration. Pathlines for the movements of infinitesimal particles are constructed and the geometric changes of these pathlines are used to establish the criterion for blocking and trapping particles with different physical properties. The sharp corners of the sawtooth channel create much stronger dielectrophoretic force than channels with smooth corners for blocking particle movements. Particle blocking and trapping depend on particle properties and the geometry of the device. It is shown that once the channel geometric aspect ratios are specified, the blocking criterion depends on only a single dimensionless parameter C defined in terms of the particle mobility ratio (dielectrophoretic versus electrokinetic), the applied voltage and the spacing between the teeth. Selective blocking and trapping of particles can be realized by varying the geometry of the channel progressively. High-resolution separation can be achieved by tuning the differential in the parameter C to a desired level.

Here we report a novel method for the manipulation and concentration of Aβ amyloid fibrils, implicated in Alzheimer's disease, using DC insulating gradient dielectrophoresis (DC-iGDEP). Fibril enrichment was found to be ∼400%. Simulations suggest that capture of the full range of amyloid protein aggregates is possible with optimized device design.

Biological fluids can be considered to contain information-rich mixtures of biochemicals and particles that enable clinicians to accurately diagnose a wide range of pathologies. Rapid and inexpensive analysis of blood and other bodily fluids is a topic gaining substantial attention in both science and medicine. One line of development involves microfluidic approaches that provide unique advantages over entrenched technologies, including rapid analysis times, microliter sample and reagent volumes, potentially low cost, and practical portability. The present study focuses on the isolation and concentration of human blood cells from small-volume samples of diluted whole blood. Separation of cells from the matrix of whole blood was accomplished using constant potential insulator-based gradient dielectrophoresis in a converging, sawtooth-patterned microchannel. The channel design enabled the isolation and concentration of specific cell types by exploiting variations in their characteristic physical properties. The technique can operate with isotonic buffers, allowing capture of whole cells, and reproducible capture occurred at specific locales within the channel over a global applied voltage range of 200-700 V.

Here we present a scheme to separate particles according to their characteristic physical properties, including size, charge, polarizability, deformability, surface charge mobility, dielectric features, and local capacitance. Separation is accomplished using a microdevice based on direct current insulator gradient dielectrophoresis that can isolate and concentrate multiple analytes simultaneously at different positions. The device is dependent upon dielectrophoretic and electrokinetic forces incorporating a global longitudinal direct current field as well as using shaped insulating features within the channel to induce local gradients. This design allows for the production of strong local field gradients along a global field causing particles to enter, initially transported through the channel by electrophoresis and electroosmosis (electrokinetics), and to be isolated via repulsive dielectrophoretic forces that are proportional to an exponent of the field gradient. Sulfate-capped polystyrene nano and microparticles (20, 200 nm, and 1 μm) were used as probes to demonstrate the influence of channel geometry and applied longitudinal field on separation behavior. These results are consistent with models using similar channel geometry and indicate that specific particulate species can be isolated within a distinct portion of the device, whereas concentrating particles by factors from 10(3) to 10(6).