No abstract

Redox electrolyte contacts offer a simple way of testing the photocurrent generation/collection efficiency in partially completed thin-film solar cells without the need to complete the entire fabrication process. However, the development of a reliable quantitative method can be complicated by the instability of the semiconductor/electrolyte interface. In the case of Cu(In,Ga)Se 2 (CIGSe) solar cells, these problems can be overcome by using samples that have undergone the next processing step in solar cell fabrication, which involves chemical bath deposition of a thin (ca. 50 nm) CdS buffer layer. The choice of redox system is also critical. The frequently used Eu 3+/2+ redox couple is not suitable for reliable performance predictions since it suffers from very slow electron transfer kinetics. This leads to the buildup of photogenerated electrons near the interface, resulting in electron−hole recombination. This effect, which can be seen in the transient photocurrent response, has been quantified using intensity-modulated photocurrent spectroscopy (IMPS). The study has demonstrated that the more oxidizing Fe(CN) 6 3−/4− redox system can be used when a CdS buffer layer is deposited on the CIGSe absorber. The wide bandgap CdS acts as a barrier to hole injection, preventing decomposition of the CIGSe and formation of surface recombination centers. The IMPS response of this system shows that there is no recombination; i.e., electron scavenging is very rapid. It is shown that measurements of the external quantum efficiency made using the Fe(CN) 6 3−/4− redox couple with CdS-coated CIGSe layers can provide reliable predictions of the short-circuit currents of the complete solar cells. Similar results have been obtained using CdScoated GaAs layers, suggesting that the new approach may be widely applicable.

No abstract

Micro-concentrator solar cells enable higher power conversion efficiencies and material savings when compared to large-area non-concentrated solar cells. In this study, we use materials-efficient area-selective electrodeposition of the metallic elements, coupled with selenium reactive annealing, to form Cu(In,Ga)Se2 semiconductor absorber layers in patterned microelectrode arrays. This process achieves significant material savings of the low-abundance elements. The resulting copper-poor micro-absorber layers’ composition and homogeneity depend on the deposition charge, where higher charge leads to greater inhomogeneity in the Cu/In ratio and to a patchy presence of a CuIn5Se8 OVC phase. Photovoltaic devices show open-circuit voltages of up to 525 mV under a concentration factor of 18 ×, which is larger than other reported Cu(In,Ga)Se2 micro-solar cells fabricated by materials-efficient methods. Furthermore, a single micro-solar cell device, measured under light concentration, displayed a power conversion efficiency of 5% under a concentration factor of 33 ×. These results show the potential of the presented method to assemble micro-concentrator photovoltaic devices, which operate at higher efficiencies while using light concentration.

No abstract