The discovery of materials that combine selectively, controllably, and reversibly with CO2 is a key challenge for realizing practical carbon capture from flue gas and other point sources. We report the design of ionic liquids (ILs) with properties tailored to this CO2 separation problem. Atomistic simulations predict that suitably substituted aprotic heterocyclic anions, or “AHAs,” bind CO2 with energies that can be controlled over a wide range suitable to gas separations. Further, unlike all previously known CO2-binding ILs, the AHA IL viscosity is predicted to be insensitive to CO2. Spectroscopic, temperature-dependent absorption, rheological, and calorimetric measurements on trihexyl(tetradecyl)-phosphonium 2-cyanopyrrolide ([P66614][2-CNpyr]) show CO2 uptakes close to prediction as well as insignificant changes in viscosity in the presence of CO2. A pyrazolide-based AHA IL behaves qualitatively similarly but with weaker binding energy. The results demonstrate the intrinsic design advantages of ILs as a platform for CO2 separations.

Ionic liquids (ILs) with aprotic heterocyclic anions, or AHAs, can bind CO2 with reaction enthalpies that are suitable for gas separations and without suffering large viscosity increases. In the present work, we have synthesized ILs bearing an alkyl-phosphonium cation with indazolide, imidazolide, pyrrolide, pyrazolide and triazolide-based anions that span a wide range of predicted reaction enthalpies with CO2. Each AHA-based IL was characterized by NMR spectroscopy and their physical properties (viscosity, glass transition, and thermal decomposition temperature) determined. In addition, the influence of substituent groups on the reaction enthalpy was investigated by measuring the CO2 solubility in each IL at pressures between 0 and 1 bar at 22 °C using a volumetric method. The isotherm-derived enthalpies range between -37 and -54 kJ mol(-1) of CO2, and these values are in good agreement with computed enthalpies of gas-phase IL-CO2 reaction products from molecular electronic structure calculations. The AHA ILs show no substantial increase in viscosity when fully saturated with CO2 at 1 bar. Phase splitting and compositional analysis of one of the IL/H2O and IL/H2O/CO2 systems conclude that protonation of the 2-cyanopyrrolide anion is improbable, and this result was confirmed by the equimolar CO2 absorption in the presence of water. Taking advantage of the tunable binding energy and absence of viscosity increase after the reaction with CO2, AHA ILs are promising candidates for efficient and environmental-friendly absorbents in postcombustion CO2 capture.

A series of tetraalkylphosphonium 2-cyanopyrrolide ([Pnnnn][2-CNPyr]) ionic liquids (ILs) were prepared to investigate the effect of cation size on physical properties and CO2 solubility. Each IL was synthesized in our laboratory and characterized by NMR spectroscopy. Their physical properties, including density, viscosity, and ionic conductivity, were determined as a function of temperature and fit to empirical equations. The density gradually increased with decreasing cation size, while the viscosity decreased noticeably. In addition, the [Pnnnn][2-CNPyr] ILs with large cations exhibited relatively low degrees of ionicity based on analysis of the Walden plots. This implies the presence of extensive ion pairing or formation of aggregates resulting from van der Waals interactions between the long hydrocarbon substituents. The CO2 solubility in each IL was measured at 22 °C using a volumetric method. While the anion is typically known to be predominantly responsible for the CO2 capture reaction, the [Pnnnn][2-CNPyr] ILs with shorter alkyl chains on the cations exhibited slightly stronger CO2 binding ability than the ILs with longer alkyl chains. We attribute this to the difference in entropy of reaction, as well as the variation in the relative degree of ionicity.

Phase-change ionic liquids, or PCILs, are salts that are solids at normal flue gas processing temperatures (e.g., 40− 80 °C) and that react stoichiometrically and reversibly with CO 2 (one mole of CO 2 for every mole of salt at typical postcombustion flue gas conditions) to form a liquid. Thus, the melting point of the PCIL−CO 2 complex is below that of the pure PCIL. A new concept for CO 2 separation technology that uses this key property of PCILs offers the potential to significantly reduce parasitic energy losses incurred from postcombustion CO 2 capture by utilizing the heat of fusion (ΔH fus ) to provide part of the heat needed to release CO 2 from the absorbent. In addition, the phase transition yields almost a step-change absorption isotherm, so only a small pressure or temperature swing is required between the absorber and the stripper. Utilizing aprotic heterocyclic anions (AHAs), the enthalpy of reaction with CO 2 can be readily tuned, and the physical properties, such as melting point, can be adjusted by modifying the alkyl chain length of the tetra-alkylphosphonium cation. Here, we present data for four tetrabutylphosphonium salts that exhibit PCIL behavior, as well as detailed measurements of the CO 2 solubility, physical properties, phase transition behavior, and water uptake for tetraethylphosphonium benzimidazolide ([P 2222 ][BnIm]). The process based on [P 2222 ][BnIm] has the potential to reduce the amount of energy required for the CO 2 capture process substantially compared to the current technology that employs aqueous monoethanolamine (MEA) solvents.

We synthesized ionic liquids (ILs) comprising an alkylphosphonium cation paired with phenolate, 4-nitrophenolate, and 4-methoxyphenolate anions that span a wide range of predicted reaction enthalpies with CO2. Each phenolate-based IL was characterized by spectroscopic techniques, and their physical properties (viscosity, conductivity, and CO2 solubility) were determined. We use the computational quantum chemical approach paired with experimental results to reveal the reaction mechanism of CO2 with phenolate ILs. Model chemistry shows that the oxygen atom of phenolate associates strongly with phosphonium cations and is able to deprotonate the cation to form an ylide with an affordable activation barrier. The ATR-FTIR and (31)P NMR spectra indicate that the phosphonium ylide formation and its reaction with CO2 are predominantly responsible for the observed CO2 uptake rather than direct anion-CO2 interaction.