RESUMO:Objetivou-se, com este trabalho, analisar a variabilidade da cor da madeira nas seções anatômicas (radial, tangencial e transversal) das espécies Breu-vermelho, Tauari-vermelho e Pequiarana, por meio de colorimetria quantitativa, utilizando o sistema CIELAB de cores. As espécies são provenientes da área de exploração florestal da empresa Mil Madeiras Preciosas, localizada no município de Itacoatiara/AM. Foram selecionadas 5 amostras da madeira de cada espécie, sendo determinados os parâmetros colorimétricos: L*, a*, b*, C e h*. Foram realizadas 225 medições no total, por meio do espectrofotômetro Konica Minolta CM-5 acoplado ao computador. As espécies Breu-vermelho, Tauari-vermelho e Pequiarana apresentaram diferenças estatísticas nos parâmetros colorimétricos, e baixa saturação na coordenada a*. De acordo com agrupamento de Cluster, a madeira de Breu-vermelho é oliva e/ou rosa-acinzentada, Tauarivermelho é cinza-rosado e Pequiarana é rosa-acinzentado e/ou cinza-rosado. As espécies florestais apresentaram diferença de cor entre os planos anatômicos (radial, tangencial e transversal), sendo influenciados pela coloração amarela, definida no parâmetro b*. A utilização da colorimetria para conhecimento da cor da madeira mostrou-se de aplicação simples e podendo ser empregada desde o desdobro da tora, até aproveitamento final, com possibilidade de agregação de valor ao produto. COLORIMETRIC CHARACTERIZATION OF THREE WOOD SPECIES FROM THE AMAZON FORESTABSTRACT: The aim of this study was to analyze wood color variability in the (radial, tangential and transversal) anatomic sections of Breu-vermelho, Tauari-vermelho and Pequiarana species through quantitative colorimetry using CIELAB color system. Such species come from a forest sustainable area of Thousand Precious Woods Company, located in Itacoatiara in the Amazon region of Brazil. Five wood samples from each species were selected so as to determine the following colorimetric parameters: L*, a*, b*, C e h*. In addition, 225 measurements were carried out with Konica Minolta CM-5 spectrophotometer connected to the computer. Results pointed out to statistical differences in the colorimetric parameters and also a low saturation in a* in the analyzed species. According to the cluster gathering, Breu-vermelho wood presents olive and/or grayish pink color, Tauari-vermelho is pinkish-gray and Pequiarana is grayish-pink and/ or pinkish-gray. Such species presented differences in color among the three anatomic sections cited above and were also influenced by the yellow color defined in b* parameter. To summarize, colorimetric analysis to establish wood color is a simple procedure which may be used from the sawing of the logs until their final exploitation enabling value aggregation to the final product.
ResumoAs espécies florestais Acacia mangium, Inga edulis e Tachigalia chrysophyllum foram pré-selecionadas para utilização em plantios energéticos. Com o objetivo de caracterizar essas espécies, foram realizados testes a partir das variáveis densidade básica, poder calorífico e análise imediata. O experimento foi implantado na Estação Experimental da EMBRAPA no município de Iranduba/AM. O delineamento foi em blocos ao acaso com três repetições, perfazendo 9 parcelas compostas de 25 plantas cada. Foram retiradas cinco árvores dentre as nove centrais da área útil. Destas, foram retirados os discos com 5 cm de espessura e desdobrados em corpos de prova, para se determinar a densidade básica e demais testes. Realizou-se análise de variância e teste de Tukey a 5% de probabilidade. A Acacia mangium (24,16 cm – 13,09 m) superou as demais em diâmetro e altura, respectivamente. Os dados médios obtidos para densidade básica classificam todas as espécies como madeira de densidade baixa, média e levemente densa. O poder calorífico observado em Acacia mangium (4430,37 kcal/kg) foi estatisticamente superior às demais espécies. Na análise imediata, as espécies apresentaram resultados satisfatórios, sendo apontadas como madeiras adequadas para uso no processo da queima. Os resultados demonstram que as espécies possuem qualidade para produção de lenha.AbstractEnergetic characterization of native and exotic forest species cultivated at Amazonas. The forest species Acacia mangium, Inga edulis and Tachigalia chrysophyllum were pre-selected to be used at energetic crops. In order to their characterization, tests of basic density, heating power and immediate analysis were performed. The experiment was carried out at EMBRAPA’s Experimental Station, located at Iranduba/AM and was designed as randomized blocks, with three repetitions, comprising 9 plots with 25 plants each. Five trees were removed from the nine central ones of the utile area. Discs of 5 cm thick were removed from them and divided into proof bodies to evaluate basic density and other variables. Analysis of variance and Tukey test at 5% of probability were done. Acacia mangium (20.82 cm – 13.41 m) presented greater diameter and height, respectively, than the other species. The data of basic density average classified all three species as low, medium and dense-lightly density wood. The heating power observed for Acacia mangium (4430.37 kcal/kg) was statistically superior to other species. All three species presented satisfactory results at immediate analysis, being identified as suitable woods for use in burning process. Results show that the species present quality for fire wood production.Keywords: Biomass; basic density; heating power; immediate analysis; planting.
In the Amazon, the sustainable use of wood is associated with technological research that indicates industrial use. Surface roughness of wood is an important criterion for assessing tool condition, machining performance and product quality. The objective of this study was to evaluate the surface roughness of five Amazonian woods used in the manufacture of EGP (Edge Glued Panels).The woods Angelim pedra, Angelim vermelho, Breu vermelho, Murici and Piãozinho, obtained from managed areas of the Amazon, were used in the manufacture of EGP panels. Surface treatments were performed with 120 and 180 grit sandpaper. Surface ripples (roughness) were measured using a digital roughness meter with needle (n = 180 readings). Physical and mechanical tests were performed on both wood and EGP samples, to verify the possible relationship between these properties and roughness. EGP Piãozinho presented better surface quality, which consists of lower roughness (lower surface wave height), while EGP Angelim pedra presented uneven surfaces. Surface quality was satisfactory when 120 grain sandpaper was applied to most products. The results showed a highly significant effect of roughness such as the physical-mechanical properties. The highlight of the study is the wood and EGP Piãozinho, because in all the tests, it always presented the best performances.
RESUMO A densidade básica é uma das propriedades mais estudadas na tecnologia da madeira, visto sua importância na correlação com as propriedades físicas e mecânicas. A metodologia tradicional (destrutiva) demanda altos custos e extenso período para execução dos ensaios. Neste sentido, a pesquisa desenvolvida buscou determinar a densidade da madeira de Eschweilera odora por metodologia não destrutiva, avaliando a eficiência da espectroscopia no infravermelho próximo-NIR. Madeiras provenientes de floresta secundária de terra firme (Amazonas/Brasil) foram selecionadas para estudo, onde oito replicadas da espécie Eschweilera odora foram utilizadas para validação da densidade e 11 espécies (64 amostras) utilizadas na construção do modelo PLS/NIR. Os espectros NIR das madeiras foram coletados na faixa de 4.000-10.000 cm-1 , onde a análise espectral possibilitou associar espectros x densidade. Os modelos utilizados para estimar a densidade de Eschweilera odora nas faces tangenciais e radiais apresentaram altos índices de determinação (R 2 > 0,90) e baixos erros (Calibração/RMSEC e previsão/RMSEP). O teste T mostrou que a diferença entre os valores da densidade de Eschweilera odora preditos pelos PLS Radial e Tangencial não foi significativa para um intervalo de confiança de 95%, apresentando resultados aproximados. Estes resultados confirmam a potencialidade da espectroscopia NIR para estimativa da densidade da madeira de Eschweilera odora. Palavras-chave: madeiras da Amazônia; caracterização tecnológica; NIR; metodologia não destrutiva. Estimation of the basic density of wood Eschweilera odora (Poepp.) Miers by near infrared spectroscopy ABSTRACT The basic density is one of the most studied properties in wood technology area due to its significance in the correlation with the physical and the mechanical properties. The traditional (destructive) methodology demands high costs and an extended time period for the execution of the tests. The research developed here determines the basic density of Eschweilera odora wood by non-destructive methodology, evaluating the efficiency of the near infrared spectroscopy-NIR technique. Timber from "terra firme" secondary forest (Amazonas/Brazil) was selected for our study, where eight replicates of Eschweilera odora species were used for density's validation and 11 species (64 samples) were used to construct the PLS/NIR model. The NIR spectra of the woods were collected in the range of 4,000-10,000 cm-1 , where the spectral analysis made it possible to associate spectra x density. The models used to determine the density of Eschweilera odora wood on the tangential and radial faces presented high determination indices (R 2 > 0.90) and low errors (Calibration/RMSEC and prediction/RMSEP). The T test showed that the difference between values of Eschweilera odora wood density predicted by Radial PLS and Tangential PLS were not significant 95% confidence level, showing approximate results. These results confirm the potential the NIR spectroscopy to estimate the wood density.
No município de Iranduba, Estado do Amazonas – Brasil há grande consumo de madeira pelas comunidades locais para fabricação de carvão, e pelas olarias na queima para produção de tijolos. Diante deste panorama, a EMBRAPA vem desenvolvendo um projeto visando implementar plantios nas comunidades deste município. Neste contexto, o presente trabalho tem como objetivo avaliar as espécies Acacia auriculiformis (exótica) e Ormosia paraensis (nativa) a partir das variáveis dendrométricas, determinação da densidade básica, poder calorífico e análise imediata. O experimento foi implantado na Estação Experimental da EMBRAPA no município de Iranduba. O delineamento foi em blocos ao acaso com três repetições perfazendo um total de 6 parcelas compostas de 25 plantas cada. Foram retiradas cinco árvores dentre as nove centrais da área útil. Destas foram retirados os discos com 5cm espessura e desdobrados em corpos de prova para determinar a densidade básica e demais testes. Foi efetuada a análise de variância e teste de Tukey a 5% de probabilidade para todos os testes realizados. A A. auriculiformis (23,61cm-15,90m) superou a O. paraensis (7,26 cm7,06 m) em diâmetro a altura, respectivamente. As espécies mostraram densidade média, onde A. auriculiformis (0,63 g/cm3) superou a O. paraensis (0,55 g/cm3) . O potencial calorífico encontrado para A. auriculiformis (4383,65 kcal/kg) foi superior estatisticamente ao encontrado na O. paraensis (4381,24 kcal/kg). Na análise imediata a A. auriculiformis superou a O. paraensis, mas foi inferior em carbono fixo. Os resultados conduzem ao emprego das duas espécies para plantio por apresentaremse promissoras para o cultivo e uso final como fonte energética proposto no trabalho.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.