Biocomposite thin films assembled on colloidal particles by means of layer-by-layer adsorption have been suggested as drug carriers and diagnostic devices. Protamine (PRM)/dextransulfate (DXS) and protamine/bovine serum albumine (BSA) multilayers were fabricated on colloidal silica and subsequently investigated by means of fluorescence activated cell sorting (FACS) and microelectrophoresis. Fluorescein labeled polyelectrolytes were embedded at different positions in the multilayers as a marker for layer growth. FACS showed that PRM and DXS formed regular growing stable multilayers, yet adsorbed PRM can be nevertheless exchanged with PRM in solution during layer formation and also after the multilayer formation has been completed. Up to 90% of the PRM pool was available for exchange. PRM together with BSA as demonstrated by SFM did not form multilayers under the applied conditions although the zeta-potential, commonly used as an indicator for stepwise adsorption, observed characteristic alternations. The capability of bound PRM to exchange with PRM in solution is attributed to its relatively small size. The demonstrated exchange may have importance in designing multilayers with smart release features. Furthermore, FACS proved to be a rather suitable means to quantify the aggregation behavior during coating and washing. Singulets, doublets, triplets, and aggregates of higher order could be clearly resolved. The aggregation of particles coated with PRM/DXS layers was higher than that of silica particles coated with PAH/PSS layers. In the first case about 50% of all recorded events are attributed to aggregats, while the PAH/PSS coating produced only about 10% aggregates.

Slide‐based cytometry (SBC) and related techniques offer unique tools to perform complex immunophenotyping, thereby enabling diagnostic procedures at very early disease stages. Multicolor or polychromatic analysis of cells by SBC is of special importance, not only as a cytomics technology platform but also for patients with low blood volume such as neonates. The exact knowledge of the location of each cell on the slide allows restaining and subsequent reanalysis of the specimen. These separate measurements of the same specimen can be fused to one data file (merging), thus increasing the information obtained per cell. Relocalization and optical evaluation of the cells, a feature typical of SBC, can be of integral importance for cytometric analysis. Due to this feature, artifacts can be excluded and morphology of measured cells can be documented. Predictive medicine aims at the detection of changes in patient's state before the manifestation of the disease or its complications. Such instances concern multiorgan failure in sepsis or noninfectious posttraumatic shock in intensive care patients or the pretherapeutic identification of high‐risk patients undergoing cancer cytostatic therapy. Early anti‐infectious or antishock therapy and curative chemotherapy in combination with stem cell transplantation may provide better chances of patients' survival at concomitant cost containment. Predictive medicine that guides early individualized decrease or cessation of therapy may lower or abrogate potential therapeutic side effects (individualized medicine). Regenerative medicine concerns patients who have diseased and injured organs and may be treated with transplanted organs. However, there is a severe shortage of donor organs that is worsening yearly given the aging population. Regenerative medicine and tissue engineering apply the principles of cell transplantation, material science, and bioengineering to construct biological substitutes that will restore and maintain normal function in diseased and injured tissues. Neovascularization is promoted by bone marrow–derived endothelial progenitor cells that lead to the formation of entirely new vessels into ischemic tissue. With this knowledge, many therapeutical borders can be skipped. Diseases formerly uncontrolled can be corrected with stem cells to provide causal healing with regeneration processes. The 9th Leipziger Workshop combined with the 2nd International Workshop on SBC aimed to offer new methods in image cytometry and SBC for solutions in clinical research. It moved toward practical applications in clinics and the clinical laboratory. This development will be continued in 2005 at the upcoming Leipziger Workshop and the 3rd International Workshop on SBC. © 2005 Wiley‐Liss, Inc.

Colloids with graduated fluorescence intensities were fabricated by means of layer-wise adsorption of fluorescein isothiocyanate-labelled poly(allyl amine hydrochloride) (FITC-PAH) together with poly(styrene sulfonate) (PSS) on silica particles. The graduated fluorescence was adjusted by variation of the fluorescent layer number and mixing labelled PAH with unlabelled PAH in one layer. The graduation of fluorescence intensities was adjusted in a geometric progression. It was shown that a proper label content is crucial if self-quenching phenomena are involved. The approach of mixing FITC-PAH with unlabelled polyelectrolyte during adsorption was unsatisfactory since competition in adsorption occurs. The system shows excellent stability at least over a period of two years.