The use of AP between alloy metal surfaces and resin cements did not increase the bond strength for most cementing systems evaluated.

No abstract

Introduction: The crown preparation promotes the exposure of dentin tubules. Thus, to avoid post-operative sensitivity, the first approach involves the use of dentin adhesives, and the second one the use of dentin desensitizers. Objective: This study evaluated the effect of dentin desensitizers on microtensile bond strengths (µTBSs) of a resin cement to dentin. Material and methods: Twenty bovine teeth were prepared until obtaining flat dentin surfaces. A standardized smear layer was created (#600-grit SiC paper). The samples were randomly divided into the following four groups (n = 5): no treatment (Control), treatment with Gluma Desensitizer (Heraeus Kulzer), Super Seal (Phoenix Dental) and Teethmate Desensitizer (Kuraray Noritake Dental). The dentin surfaces were then treated with ED Primer II (Kuraray Noritake Dental). Twenty composite blocks, 4 mm thick (Estenia C&B, Kuraray Noritake Dental) were used. The composite surfaces were abraded with aluminum oxide (50 µm), and then silanized. The composite block was bonded to the dentin surface with a resin cement (Panavia F 2.0, Kuraray Noritake Dental) according to