A novel low-cost method for the combined, real-time, and in situ determination of dissolved methane and carbon dioxide concentrations in freshwater ecosystems was designed and developed. This method is based on the continuous sampling of water from a freshwater ecosystem to a gas/liquid exchange membrane. Dissolved gas is transferred through the membrane to a continuous flow of high purity nitrogen, which is then measured by an off-axis integrated cavity output spectrometer (OA-ICOS). This method, called M-ICOS, was carefully tested in a laboratory and was subsequently applied to four lakes in Mexico and Alaska with contrasting climates, ecologies, and morphologies. The M-ICOS method allowed for the determination of dissolved methane and carbon dioxide concentrations with a frequency of 1 Hz and with a method detection limit of 2.76 × 10(-10) mol L(-1) for methane and 1.5 × 10(-7) mol L(-1) for carbon dioxide. These detection limits are below saturated concentrations with respect to the atmosphere and significantly lower than the minimum concentrations previously reported in lakes. The method is easily operable by a single person from a small boat, and the small size of the suction probe allows the determination of dissolved gases with a minimized impact on shallow freshwater ecosystems.

No abstract

No abstract

No abstract

An open dynamic chamber for the continuous monitoring of diffusive and ebullitive fluxes of methane (CH4) in aquatic ecosystems was designed and developed. This method is based on a standard floating chamber in which a well-defined carrier gas flows. The concentration of CH4 is measured continuously at the outlet of the chamber, and the flux is determined from a mass balance equation. The method was carefully tested in a laboratory and was subsequently applied to two lakes, in Mexico, with contrasting trophic states. We show here that the method allows for the continuous quantification of CH4 diffusive flux higher than 25 × 10–6 g m–2 h–1, the determination of ebullitive flux, and the individual characterization of bubbles larger than 1.50–1.72 mm in diameter. The method was also applied to determine carbon dioxide emissions (CO2). In that case, the method was less sensitive but allowed for the characterization of diffusive fluxes higher than 10 mg CO2 m–2 h–1 and of bubbles larger than 5.3–8.4 mm in diameter. This high-throughput method can be adapted to any gas detector at low cost, making it a convenient tool to better constrain greenhouse gas emission from freshwater ecosystems.