The present study shows a comparison between two sintering processes, microwave and conventional sintering, for the manufacture of NiTi porous specimens starting from powder mixtures of nickel and titanium hydrogenation–dehydrogenation (HDH) milled by mechanical alloying for a short time (25 min). The samples were sintered at 850 °C for 15 min and 120 min, respectively. Both samples exhibited porosity, and the pore size results are within the range of the human bone. The NiTi intermetallic compound (B2, R-phase, and B19′) was detected in both sintered samples through X-ray diffraction (XRD) and electron backscattering diffraction (EBSD) on scanning electron microscopic (SEM). Two-step phase transformation occurred in both sintering processes with cooling and heating, the latter occurring with an overlap of the peaks, according to the differential scanning calorimetry (DSC) results. From scanning electron microscopy/electron backscatter diffraction, the R-phase and B2/B19′ were detected in microwave and conventional sintering, respectively. The instrumented ultramicrohardness results show the highest elastic work values for the conventionally sintered sample. It was observed throughout this investigation that using mechanical alloying (MA) powders enabled, in both sintering processes, good results, such as intermetallic formation and densification in the range for biomedical applications.
Reducing pollutant emissions and improving safety standards are primary targets for modern mobility improvement. To meet these needs, the development of low-density steels containing aluminum is a new frontier of research for automotive applications. Low-density Fe-Mn-Al-C alloys are promising. In this regard, an alloy with high aluminum content and niobium addition belonging to the Fe-Mn-Al-C system was evaluated to understand the possible phase transformations and thus obtain a transformation diagram by continuous cooling to help future processing. Dilatometry tests were performed in a Gleeble thermomechanical simulator with different cooling rates (1, 3, 5, 10, 15, 20, 30, and 50 °C/s). Chemical analyses carried out simultaneously with dilatometry tests showed the presence of proeutectoid ferrite (αp), δ-ferrite, retained austenite, and niobium carbide (NbC). In the case of low cooling rates (1 and 3 °C/s), lamellar colonies of the eutectoid microconstituents were observed with a combination of α-ferrite and k-carbide. For higher cooling rates (5 to 50 °C/s), martensite was observed with body-centered cubic (BCC) and body-centered tetragonal (BCT) structures.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.