This note provides an interim summary of the current recommendations of the PDF4LHC working group for the use of parton distribution functions (PDFs) and of PDF uncertainties at the LHC, for cross section and cross section uncertainty calculations. It also contains a succinct user guide to the computation of PDFs, uncertainties and correlations using available PDF sets.A companion note (the PDF4LHC Working Group Interim Report) summarizes predictions for benchmark cross sections at the LHC at NLO using modern PDFs currently available from 6 PDF fitting groups.

Flash-cooling and annealing of macromolecular crystals have been investigated using in situ X-ray imaging, diffraction-peak lineshape measurements and conventional crystallographic diffraction. The dominant mechanisms by which¯ash-cooling creates disorder are suggested and a ®xed-temperature annealing protocol for reducing this disorder is demonstrated that should be more reliable and¯exible than existing protocols. Flash-cooling tetragonal lysozyme crystals degrades diffraction resolution and broadens the distributions of lattice orientations (mosaicity) and lattice spacings. The diffraction resolution strongly correlates with the width of the latticespacing distribution. Annealing at ®xed temperatures of 253 and 233 K consistently reduces the lattice-spacing spread and improves the resolution for annealing times up to $30 s. X-ray images show that this improvement arises from the formation of well ordered domains with characteristic sizes >10 mm and narrower mosaicities than the crystal as a whole. Flash-cooled triclinic crystals of lysozyme, which have a smaller water content than the tetragonal form, diffract to higher resolution with smaller mosaicities and exhibit pronounced ordered domain structure even before annealing. It is suggested that differential thermal expansion of the protein lattice and solvent may be the primary cause of¯ash-cooling-induced disorder. Mechanisms by which annealing at T << 273 K reduce this disorder are discussed.

The dependence of radiation damage to protein crystals at cryogenic temperatures upon the X-ray absorption cross-section of the crystal has been examined. Lysozyme crystals containing varying heavy-atom concentrations were irradiated and diffraction patterns were recorded as a function of the total number of incident photons. An experimental protocol and a coefficient of sensitivity to absorbed dose, proportional to the change in relative isotropic B factor, are defined that together yield a sensitive and robust measure of damage. Radiation damage per incident photon increases linearly with the absorption coefficient of the crystal, but damage per absorbed photon is the same for all heavy-atom concentrations. Similar damage per absorbed photon is observed for crystals of three proteins with different molecular sizes and solvent contents.

Determining the interconverting conformations of dynamic proteins in atomic detail is a major challenge for structural biology. Conformational heterogeneity in the active site of the dynamic enzyme cyclophilin A (CypA) has been previously linked to its catalytic function, but the extent to which the different conformations of these residues are correlated is unclear. Here we compare the conformational ensembles of CypA by multitemperature synchrotron crystallography and fixed-target X-ray free-electron laser (XFEL) crystallography. The diffraction-before-destruction nature of XFEL experiments provides a radiation-damage-free view of the functionally important alternative conformations of CypA, confirming earlier synchrotron-based results. We monitored the temperature dependences of these alternative conformations with eight synchrotron datasets spanning 100-310 K. Multiconformer models show that many alternative conformations in CypA are populated only at 240 K and above, yet others remain populated or become populated at 180 K and below. These results point to a complex evolution of conformational heterogeneity between 180-–240 K that involves both thermal deactivation and solvent-driven arrest of protein motions in the crystal. The lack of a single shared conformational response to temperature within the dynamic active-site network provides evidence for a conformation shuffling model, in which exchange between rotamer states of a large aromatic ring in the middle of the network shifts the conformational ensemble for the other residues in the network. Together, our multitemperature analyses and XFEL data motivate a new generation of temperature- and time-resolved experiments to structurally characterize the dynamic underpinnings of protein function.DOI: http://dx.doi.org/10.7554/eLife.07574.001

Three problems involving heat transfer from a protein crystal to a cooling agent are analyzed: flash-cooling in a cold nitrogen- or helium-gas stream, plunge-cooling into liquid nitrogen, propane or ethane and crystal heating in a cold gas stream owing to X-ray absorption. Heat transfer occurs by conduction inside the crystal and by convection from the crystal's outer surface to the cooling fluid. For flash-cooling in cold gas streams, heat transfer is limited by the rate of external convection; internal temperature gradients and crystal strains during cooling are very small. Helium gas provides only a threefold improvement in cooling rates relative to nitrogen because its much larger thermal conductivity is offset by its larger kinematic viscosity. Characteristic cooling times vary with crystal size L as L(3/2) and theoretical estimates of these times are consistent with experiments. Plunge-cooling into liquid cryogens, which can give much smaller convective thermal resistances provided that surface boiling is eliminated, can increase cooling rates by more than an order of magnitude. However, the internal conduction resistance is no longer negligible, producing much larger internal temperature gradients and strains that may damage larger crystals. Based on this analysis, factors affecting the success of flash-cooling experiments can be ordered from most to least important as follows: (1) crystal solvent content and solvent composition, (2) crystal size and shape, (3) amount of residual liquid around the crystal, (4) cooling method (liquid plunge versus gas stream), (5) choice of gas/liquid and (6) relative speed between cooling fluid and crystal. Crystal heating by X-ray absorption on present high-flux beamlines should be small. For a fixed flux and illuminated area, heating can be reduced by using crystals with areas normal to the beam that are much larger than the beam area.