The chemical speciation of arsenic in sediments and porewaters of aquifers is the critical factor that determines whether dissolved arsenic accumulates to potentially toxic levels. Sequestration of arsenic in solid phases, which may occur by adsorption or precipitation processes, controls dissolved concentrations. We present synchrotron x-ray absorption spectra of arsenic in shallow aquifer sediments that indicate the local structure of realgar (AsS) as the primary arsenic-bearing phase in sulfate-reducing conditions at concentrations of 1-3 mmol⅐kg ؊1 , which has not previously been verified in sediments at low temperature. Spectroscopic evidence shows that arsenic does not substitute for iron or sulfur in iron sulfide minerals at the molecular scale. A general geochemical model derived from our field and spectroscopic observations show that the ratio of reactive iron to sulfur in the system controls the distribution of solid phases capable of removing arsenic from solution when conditions change from oxidized to reduced, the rate of which is influenced by microbial processes. Because of the difference in solubility of iron versus arsenic sulfides, precipitation of iron sulfide may remove sulfide from solution but not arsenic if precipitation rates are fast. The lack of incorporation of arsenic into iron sulfides may result in the accumulation of dissolved As(III) if adsorption is weak or inhibited. Aquifers particularly at risk for such geochemical conditions are those in which oxidized and reduced waters mix, and where the amount of sulfate available for microbial reduction is limited. Despite intensive study in recent years, quantitative biogeochemical models that explain and predict conditions controlling the uptake or release of dissolved arsenic in groundwaters remain incomplete, due partly to a lack of knowledge of arsenic speciation in subsurface sediments. Worldwide, elevated concentrations of arsenic (Ͼ10 g⅐liter Ϫ1 , the World Health Organization and new U.S. Environmental Protection Agency drinking-water standard) in groundwater have the potential to have an adverse impact on Ϸ90 million people (1, 2), including 13 million in the United States (3, 4). Arsenic is a known carcinogen and mutagen that can lead to both acute and chronic adverse health effects (5, 6). Arsenic in ground-and surface waters results from both natural and anthropogenic sources, but its mobility and attenuation, and thus impact on humans and other organisms, is directly tied to its chemical speciation (3,7,8).Recent studies using direct spectroscopic characterizations have begun to verify differing chemical states of arsenic in natural samples and their influence on arsenic mobility (9-12). Under oxic conditions, it is widely accepted that arsenic in sediments is removed from solution by adsorption to or coprecipitation with ferric oxyhydroxide and possibly by adsorption to manganese oxide and phyllosilicate minerals (7, 13). As subsurface conditions change from oxidized to progressively more reduced, As(V) is reduced to As(III...

No abstract

No abstract

Mine wastes introduce anthropogenic weathering profiles to the critical zone that often remain unvegetated for decades after mining cessation. As such, they are vulnerable to wind and water dispersion of particulate matter to adjacent ecosystems and residential communities. In sulfide-rich ore tailings, propagation to depth of the oxidative weathering front controls the depth-variation in speciation of major and trace elements. Despite the prevalence of surficial mine waste deposits in arid regions of the globe, few prior studies have been conducted to resolve the near-surface profile of sulfide ore tailings weathered under semi-arid climate. We investigated relations between gossan oxidative reaction-front propagation and the molecular speciation of iron and sulfur in tailings subjected to weathering under semi-arid climate at an EPA Superfund Site in semi-arid central Arizona (USA). Here we report a multi-method data set combining wet chemical and synchrotron-based X-ray diffraction (XRD) and X-ray absorption near-edge spectroscopy (XANES) methods to resolve the tight coupling of iron (Fe) and sulfur (S) geochemical changes in the top 2 m of tailings. Despite nearly invariant Fe and S concentration with depth (130–140 and 100–120 g kg−1, respectively), a sharp redox gradient and distinct morphological change was observed within the top 0.5 m, associated with a progressive oxidative alteration of ferrous sulfides to (oxyhydr)oxides and (hydroxy)sulfates. Transformation is nearly complete in surficial samples. Trends in molecular-scale alteration were co-located with a decrease in pH from 7.3 to 2.3, and shifts in Fe and S lability as measured via chemical extraction. Initial weathering products, ferrihydrite and gypsum, transform to schwertmannite, then jarosite-group minerals with an accompanying decrease in pH. Interestingly, thermodynamically stable phases such as goethite and hematite were not detected in any samples, but ferrihydrite was observed even in the lowest pH samples, indicating its metastable persistence in these semiarid tailings. The resulting sharp geochemical speciation gradients in close proximity to the tailings surface have important implications for plant colonization, as well as mobility and bioavailability of co-associated toxic metal(loid)s.

Toxic metalliferous mine-tailings pose a significant health risk to ecosystems and neighboring communities from wind and water dispersion of particulates containing high concentrations of toxic metal(loid)s (e.g., Pb, As, Zn). Tailings are particularly vulnerable to erosion before vegetative cover can be reestablished, i.e., decades or longer in semi-arid environments without intervention. Metal(loid) speciation, linked directly to bioaccessibility and lability, is controlled by mineral weathering and is a key consideration when assessing human and environmental health risks associated with mine sites. At the semi-arid Iron King Mine and Humboldt Smelter Superfund site in central Arizona, the mineral assemblage of the top 2 m of tailings has been previously characterized. A distinct redox gradient was observed in the top 0.5 m of the tailings and the mineral assemblage indicates progressive transformation of ferrous iron sulfides to ferrihydrite and gypsum, which, in turn weather to form schwertmannite and then jarosite accompanied by a progressive decrease in pH (7.3 to 2.3). Within the geochemical context of this reaction front, we examined enriched toxic metal(loid)s As, Pb, and Zn with surficial concentrations 41.1, 10.7, 39.3 mM kg-1 (3080, 2200, and 2570 mg kg-1), respectively. The highest bulk concentrations of As and Zn occur at the redox boundary representing a 1.7 and 4.2 fold enrichment relative to surficial concentrations, respectively, indicating the translocation of toxic elements from the gossan zone to either the underlying redox boundary or the surface crust. Metal speciation was also examined as a function of depth using X-ray absorption spectroscopy (XAS). The deepest sample (180 cm) contains sulfides (e.g., pyrite, arsenopyrite, galena, and sphalerite). Samples from the redox transition zone (25-54 cm) contain a mixture of sulfides, carbonates (siderite, ankerite, cerrusite, and smithsonite) and metal(loid)s sorbed to neoformed secondary Fe phases, principally ferrihydrite. In surface samples (0-35 cm), metal(loid)s are found as sorbed species or incorporated into secondary Fe hydroxysulfate phases, such as schwertmannite and jarosites. Metal-bearing efflorescent salts (e.g., ZnSO4·nH2O) were detected in the surficial sample. Taken together, these data suggest the bioaccessibility and lability of metal(loid)s are altered by mineral weathering, which results in both the downward migration of metal(loid)s to the redox boundary, as well as the precipitation of metal salts at the surface.