This study characterized the coagulation properties and defined the cutting window (CW; time between storage modulus values of 35 and 70 Pa) using rheometry for milk standardized to 4, 5, or 6% protein and set at 28, 32, or 36°C. Milks were standardized to a protein-to-fat ratio of approximately 1 by blending ultrafiltration retentate, skim milk, and whole milk. The internal curd microstructure for selected curd samples was analyzed with transmission electron microscopy and scanning electron microscopy. Lowering the coagulation temperature caused longer rennet coagulation time and time to reach storage modulus of 35 Pa, translating into a wider CW. It also led to a lower maximum curd-firming rate (MCFR) with lower firmness at 40 min at a given protein level. Increasing protein levels resulted in the opposite effect, although without an effect on rennet coagulation time at a given temperature. On coagulation at 28°C, milk with 5% protein resulted in a similar MCFR (~4 Pa/min) and CW (~8.25 min) compared with milk with 4% protein at 32°C, which reflects more standard conditions, whereas increasing milk to 6% protein resulted in more than doubling of the curd-firming rate (MCFR = 9.20 Pa/min) and a shorter CW (4.60 min). Gels set at 28°C had lower levels of rearrangement of protein network after 40 min compared with those set at 36°C. Protein levels, on the other hand, had no influence on the levels of protein network rearrangement, as indicated by loss tangent values. The internal structure of curd particles, as investigated by both scanning electron microscopy and transmission electron microscopy, appeared to have less cross-linking and smaller casein aggregates when coagulated at 28°C compared with 36°C, whereas varying protein levels did not show a marked effect on ag-gregate formation. Overall, this study showed a marked interactive effect between coagulation temperature and protein standardization of milk on coagulation properties, which subsequently requires adjustment of the CW during cheesemaking. Lowering of the coagulation temperature greatly altered the curd microstructure, with a tendency for less syneresis during cutting. Further research is required to quantify the changes in syneresis and in fat and protein losses to whey due to changes in the microstructure of curd particles arising from the different coagulation conditions applied to the protein-fortified milk.

No abstract

Maasdam cheese was manufactured from standardized milk derived from each of three feeding systems: grass (GRA), grass and clover pasture (CLO), and indoor feeding of total mixed ration (TMR). Pasture‐derived cheeses had significantly lower L* (whiteness) and higher b* values (yellowness) compared to TMR‐derived cheeses. Acetate levels were significantly lower in CLO and butyrate levels significantly higher in TMR compared to the other cheeses. Grass‐fed cheese had significantly higher scores for smooth texture, ivory colour and shiny appearance compared to TMR. The influence of feed type was minimal on cheese yield, composition and on glycolysis, lipolysis and proteolysis during ripening.

BackgroundThe rate or extent of whey expulsion or syneresis from cheese curds during stirring in-vat determines curd moisture levels, which subsequently influences cheese moisture content. The outward migration of whey depends on curd contraction and on the structure of the pores permitting whey movement. Curd syneretic properties are one of the least understood areas of cheese science, particularly when milk of varying composition is used. Scope and ApproachThis review provides an insight into the mechanisms of curd formation and curd syneresis, and factors influencing syneretic properties in unconcentrated and concentrated milk and appraises syneresis measurement methods in terms of their relative strengths and weaknesses.