The purpose of this work was to study the gas yield variation resulted from the cherry wood gasification with air using a lab-scale rotary kiln gasifier. The feedstock was continuously fed into the preheated reactor at 600°C, in co-current configuration, using atmospheric air as a gasifying agent. The results indicate the importance of oxidation reaction control, through the feeding flow rates of biomass and air and the reactants mixing rate. From the experiment, the hydrogen yields were about 2-4%, while the carbon monoxide varied between 8-21%. Additionally, the paper provides process observations based on the continuous monitoring of gas composition. The specific flow rates of substances and installation operating conditions were linked to process run through syngas composition.
Using different gasification agents: air and steam, two types of gasification process were performed into a batch reactor at temperature of 750°C and 850°C and atmospheric pressure. The only difference between of the two compared experimental configurations was represented by the gasification agent used in the process. The amount of oxygen introduced into the reactor for air gasification at an ER of 0.3 was computed. Therefore, in the steam gasification process, the same amount of oxygen was introduced, so establishing an unordinary steam to biomass ratio. In this way, the two processes, air vs. steam gasification, were compared, the rest of the process parameters being kept constant. This paper approaches the transitory regimes (initiation stage) of gasification process in order to observe the influence of process temperature and gasification agent on the process run. According to the experimental results, better gas quality is obtained if steam is used as a gasifying agent, yet the conversion and energy efficiencies decreases. By optimizing time residence in steam gasification, process efficiencies may be increased.
This work aimed to study the effect of gasification process operating conditions on syngas composition and properties, and process efficiency. A rotary kiln gasifier lab-scale pilot plant with capacity ≅ 30 kg/h and a power of 30 kWe was used for gasification tests applied to cherry wood at different loads, for a temperature of about 600°C, while the air was used as gasification agent for all tests. The syngas composition was measured and analyzed. The results have shown that conversion of wood cherry through gasification lead to a lean fuel gas of 3.5 MJ/Nm3 and installation characteristics have a major influence both on process and syngas properties. This is happened because the rotary kiln gasifier allows some air infiltrations, and consequently a high N2 content in the syngas composition. The energy balance of the cherry biomass gasification processes was calculated. It was found also that gas density varies slightly from 1.26 to 1.43 kg/m3, while the specific heat of the gas varies from 1.04 to 1.34 kJ/kgK.
The paper presents the experimental results of Food Court Waste air gasification using a batch reactor. This type of waste is generated mainly in the food court areas of services spaces, shopping centers, airports and malls and is generally composed of paper & cardboard, plastic, organic, wood, metal and glass waste. The process operating parameters were: temperatures between 650°C and 850°C and an equivalent ratio of 0.25 and 0.4 respectively. The study focused on the influence of process parameters on the energy conversion rate considering the cold gas and hot gas efficiency correlated with the feedstock carbon conversion rate. The recorded instantaneous concentrations of sampled gas species were plotted in time dependent graphs for accurate variation curves of gases concentrations. The results can be used to isolate the startup stage of the gasification process and to establish the optimal process parameters for increased overall energy efficiency. In conclusion, considering the current setup, operational parameters and process energy efficiency, the optimal temperature for the air gasification of Food Court Waste is 850ºC with an equivalent ratio of 0.40.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.