Genetic parameters were estimated for a range of meat quality traits recorded on Australian lamb meat. Data were collected from Merino and crossbred progeny of Merino, terminal and maternal meat breed sires of the Information Nucleus programme. Lambs born between 2007 and 2010 (n=8968) were slaughtered, these being the progeny of 372 sires and 5309 dams. Meat quality traits were found generally to be of moderate heritability (estimates between 0.15 and 0.30 for measures of meat tenderness, meat colour, polyunsaturated fat content, mineral content and muscle oxidative capacity), with notable exceptions of intramuscular fat (0.48), ultimate pH (0.08) and fresh meat colour a* (0.08) and b* (0.10) values. Genetic correlations between hot carcass weight and the meat quality traits were low. The genetic correlation between intramuscular fat and shear force was high (-0.62). Several measures of meat quality (fresh meat redness, retail meat redness, retail oxy/met value and iron content) appear to have potential for inclusion in meat sheep breeding objectives.

The impact of selecting for lean meat yield using breeding values for increased eye muscle depth (PEMD) and decreased fat depth (PFAT) on the consumer acceptance of lamb meat was evaluated. Consumer sensory scores (tenderness, juiciness, flavour, odour, overall liking) were obtained for the longissimus lumborum (loin) and semimembranosus (topside) muscles of 1471 lambs. On average loin samples were more acceptable for consumers. Sensory scores increased with higher IMF levels, with lower shear force levels, and when animals were younger and less muscular. Increasing PEMD decreased tenderness, overall liking and flavour scores in both muscles, and decreasing PFAT reduced tenderness within the loin samples only. This negative impact of PEMD and PFAT is not solely driven through the phenotypic impact of IMF and shear force on sensory scores. Our results confirm the growing concerns that selecting for lean meat yield would reduce consumer eating quality, and highlight that careful monitoring of selection programmes is needed to maintain lamb eating quality.

Selection for lean growth through Australian Sheep Breeding Values (ASBVs) for post weaning weight (PWWT), eye muscle depth (PEMD) and c-site fat depth (PFAT) raises concerns regarding declining intramuscular fat (IMF) levels. Reducing PFAT decreased IMF by 0.84% for Terminal sired lambs. PEMD decreased IMF by 0.18% across all sire types. Female lambs had higher IMF levels and this was unexplained by total carcass fatness. The negative phenotypic association between measures of muscling (shortloin muscle weight, eye muscle area) and IMF, and positive association between fatness and IMF, was consistent with other literature. Hot carcass weight increased IMF by 2.08% between 12 and 40 kg, reflective of development of IMF as lambs approach maturity. Selection objectives with low PFAT sires will reduce IMF, however the lower impact of PEMD and absence of a PWWT effect, will enable continued selection for lean growth without influencing IMF. Alternatively, the negative impact of PFAT could be off-set by inclusion of an IMF ASBV.

Using performance from progeny born in 2007 and 2008 generated by the Information Nucleus program of the Cooperative Research Centre for Sheep Industry Innovation, preliminary estimates of heritability were obtained for a range of novel carcass and meat attributes of lamb relevant to consumers, including carcass characteristics, meat quality and nutritional value of lamb. Phenotypic and genetic correlations of live animal traits with carcass composition and meat quality traits were also estimated. The data were from progeny located at eight sites, sired by 183 rams from Merino, maternal and terminal meat breeds and were representative of the Merino, Border Leicester × Merino, Terminal × Merino and Terminal × Border Leicester-Merino production types of the Australian sheep industry. Data were available from 7176 lambs for weaning weight, 6771 lambs for ultrasound scanning and 4110 lambs for slaughter traits. For the novel meat quality traits, generally moderate to high heritability estimates were obtained for meat quality measures of shear force (0.27 aged 1 day, 0.38 aged 5 days), intramuscular fat (0.39), retail meat colour (range of 0.09 to 0.44) and myoglobin content (0.22). The nutritional value traits of omega-3 fatty acids and iron and zinc contents tended to have low to moderate heritabilities (0.11–0.37), although these were based on fewer records. Fresh meat colour traits were of low to moderate heritability (0.06–0.21) whereas measures of meat pH were of low heritability (~0.10). For the carcass traits, estimates of heritability were moderate to high for the various measures of carcass fat (0.18–0.50), muscle weight (0.22–0.35), meat yield (0.24–0.35), carcass muscle dimensions (0.25–0.34) and bone weight (0.27). Results indicate that for most lamb carcass and meat quality traits there is sufficient genetic variation for selection to alter successfully these characteristics. Additionally, most genetic correlations of live animal assessments of bodyweight, muscle and subcutaneous fat with the carcass and meat quality traits were favourable. Appropriate definition of breeding objectives and design of selection indexes should be able to account for the small unfavourable relationships that exist and achieve the desired outcomes from breeding programs.