High contact pressures applied to soil result in a greater degree of compaction, in addition to promoting other negative effects. The objective of this study was to quantify contact areas by using different methodologies, and pressures of farm equipment employed in production activity and evaluate structural changes caused in a Red Latosol with the presence and absence of straw cover. The design was completely randomized in a factorial scheme of type 4 (tire on front axle, tire on rear axle, tire on a sugarcane wagon and metallic track of sugar cane Harvester) x 2 (presence and absence of straw). The contact area (CA) of the run was obtained by three procedures: analytical measure of the area of an ellipse (CA1); digital measurement of area of an ellipse (CA2); and measurement of real contact area (RCA), with digital resources. The contact pressure was calculated from the ratio of mass of each machine's axle and the contact area of the run. The contact area obtained according to the procedure of the ellipse (CA1 and CA2) is overrated when compared to actual area obtained digitally (RCA). The straw reduces the contact pressure in the soil, due to the deep tire treads and consequently, increased contact area. Areas where the traffic of the machines occurred with soil covered with the presence of straw showed reduced soil resistance to penetration, cone index and pre-consolidation pressure, confirming that the increased contact area produced by straw reduced the pressure applied and the compression power dissipated in the soil. Index terms:Farming traction tire; farming trailer tire; metal track; wheel soil interaction. RESUMOAltas pressões de contato aplicadas ao solo resultam em um maior grau de compactação deste, além de promover outros efeitos maléficos. O objetivo deste estudo foi quantificar as áreas e pressões de contato de conjuntos motomecanizados empregados na atividade sucroalcooleira e avaliar as alterações estruturais proporcionadas em um Latossolo Vermelho com e sem cobertura de resíduos vegetais (palha). O delineamento empregado foi o inteiramente casualizado em esquema fatorial do tipo 4 (pneu acoplado no eixo dianteiro, pneu acoplado no eixo traseiro, pneu acoplado a um transbordo agrícola canavieiro e esteira metálica de colhedora de cana de açúcar) x 2 (com e sem palha na superfície). A área de contato (CA) dos rodados foi obtida por três procedimentos: medida analítica da área de uma elipse (CA1); medida digital da área de uma elipse (CA2); e medida da área de contato real (RCA), com recursos digitais. A pressão de contato foi calculada a partir da relação da massa dos eixos de cada conjunto motomecanizado e a respectiva área de contato do rodado. A área de contato obtida de acordo com o procedimento da elipse (CA1 e CA2) é superestimada quando comparada área real, obtida digitalmente (RCA). Os resíduos vegetais diminuem a pressão de contato na interface rodado-solo, devido ao maior aprofundamento das garras do rodado e por consequência, aumento da área de contato. Áreas onde o tráfego d...
Soil loss is one of the main causes of pauperization and alteration of agricultural soil properties. Various empirical models (e.g., USLE) are used to predict soil losses from climate variables which in general have to be derived from spatial interpolation of point measurements. Alternatively, Artificial Neural Networks may be used as a powerful option to obtain site-specific climate data from independent factors. This study aimed to develop an artificial neural network to estimate rainfall erosivity in the Ribeira Valley and Coastal region of the State of São Paulo. In the development of the Artificial Neural Networks the input variables were latitude, longitude, and annual rainfall and a mathematical equation of the activation function for use in the study area as the output variable. It was found among other things that the Artificial Neural Networks can be used in the interpolation of rainfall erosivity values for the Ribeira Valley and Coastal region of the State of São Paulo to a satisfactory degree of precision in the estimation of erosion. The equation performance has been demonstrated by comparison with the mathematical equation of the activation function adjusted to the specific conditions of the study area.
RESUMOO principal problema ambiental causado pelo uso do solo em áreas de preservação permanente longitudinais aos rios é a supressão da mata ciliar. O tipo e a intensidade desse uso alteram a estrutura do solo e comprometem as funções físicas dessas áreas, principalmente próximo aos cursos d'água. O objetivo deste trabalho foi avaliar a sustentabilidade estrutural, a partir do ensaio de compressão uniaxial, de três classes de solo (Cambissolo Háplico, Argissolo Amarelo e Gleissolo Háplico) e o impacto de diferentes tipos de usos do solo -não permitido pela legislação ambiental -de áreas de preservação permanente na sub-bacia do rio Ribeira de Iguape, SP. Foram delimitadas na área experimental três classes de solo: Cambissolo, Argissolo e Gleissolo. Numa primeira etapa, compararam-se as três classes de solos sob mata nativa e sob pastagem. Na segunda, avaliou-se a influência de diferentes tipos de uso do solo -cultivo de banana, pastagem degradada, uso silvipastoril e mata nativa -sobre a estrutura de um Cambissolo. A pressão de preconsolidação mostrouse ferramenta capaz de identificar a degradação nos solos. O uso do solo nas áreas de preservação permanente altera a pressão de preconsolidação do solo, causando sua degradação estrutural, colocando em risco a sustentabilidade das terras, e não deve ser permitido. O Gleissolo mostrou maiores valores de pressão de preconsolidação em função de teores crescentes de água e, portanto, maior capacidade de suporte de carga em relação ao Cambissolo e Argissolo. O cultivo de banana foi o tipo de uso que mais degradou os solos das áreas de preservação permanente.Termos de indexação: capacidade de suporte de carga, modelagem, Vale do Ribeira.(1) Recebido para publicação em 29 de março de 2011 e aprovado em 25 de junho de 2012.(2) Engenheiro-Agrônomo, Doutorando,
Precompression stress is an important property for assessment of tropical soil structure sustainability and is often determined in laboratory tests. The objective of this study was to compare the load bearing capacity models obtained with controlled moisture in laboratory and those obtained with natural field moistures determined a long one year. The evaluation of soil structural sustainability follows four distinct steps: soil sampling in the field, uniaxial compression test of the samples in the laboratory, determination of precompression stress and estimation of the load bearing capacity models. Laboratory estimates of precompression stress were obtained from moisture controlled in laboratory and from natural moisture determined in a field a long one year. In this process, the soil samples were saturated by capillarity with distilled water in laboratory, and after 48 hours, the samples were air dried to obtain the different moisture contents. Then, the precompression stress was determined for this both conditions. To verify if the load bearing capacity models obtained with controlled moisture in laboratory may represent the load bearing models obtained with natural field moisture, these models were compared using the homogeneity test procedure. It was observed that 75% of field models analyzed were similar to the laboratory models. Thus, due to the similarity on the load-bearing capacity models obtained using natural (field) or controlled (laboratory) moisture contents, the assessment of the soil structure sustainability can be done using both methods.Index terms: Agricultural traffic, Coffea Arabica L., homogeneity test, precompression stress. RESUMOPressão de pré-consolidação é uma importante propriedade na avaliação da sustentabilidade estrutural do solo e é determinada em testes de laboratório. Neste estudo, objetivou-se comparar modelos de capacidade de suporte de carga obtidos com umidade controlada em laboratório e com umidade natural de campo ao longo de um ano. A avaliação da sustentabilidade estrutural do solo ocorreu em quatro etapas: coleta de amostras de solo indeformado, ensaio de compressão uniaxial das amostras em laboratório, estimativa da pressão de pré-consolidação e obtenção dos modelos de capacidade de suporte de carga. As estimativas da pressão de pré-consolidação de laboratório e de campo foram obtidas com umidades controladas em laboratório e com umidade de campo, respectivamente, ao longo de um ano. No laboratório, a saturaçaõ das amostras se deu por capilaridade, com água destilada e depois de 48 horas, essas amostras foram secas ao ar para obter diferentes valores de umidade. Em seguida, realizou-se o ensaio de compressão uniaxial dessas amostras e a pressão de pré-consolidação foi determinada para as duas condições aqui proposta. Para verificar se os modelos de capacidade de suporte de carga com umidade controlada em laboratório podem representar os modelos de capacidade de suporte de carga de umidade natural, esses modelos foram comparados utilizando o teste de homogeneida...
It is essential to know the levels of pressure applied to the soil by different weed managements to adapt the management of coffee plantations in a sustainable manner. The objectives of this study were: a) to generate load-bearing capacity models of a Red-Yellow Latosol (Oxisol) submitted to different weed managements and b) to determine which weed management resulted in higher compression. The study was conducted at the Experimental Farm of EPAMIG, located near the community Farias, in Lavras-MG (latitude 21° 14' 43" S and longitude 44° 59' 59" W and altitude of 919 m). The soil is a Red-Yellow Latosol (LVA) cultivated with coffee plantation using Topazio MG 1190 coffee variety, since 2006. We evaluated five weed managements, three being through mechanical control (harrow (GD), mowing (RÇ) and brush (TC)) and two by chemical control (post-emergence herbicide (HPos) and pre emergence herbicide (HPre)). To obtain the load-bearing capacity models, 10 undisturbed soil samples were randomly collected in the 0-3, 10-13 and 25-28 cm layers between the rows. The load-bearing capacity models which indicated a higher compaction were: in the 0-3 cm layer, TC and GD; in the 10-13 cm layer, HPre, HPos and RÇ and in the 25-28 cm layer, GD. The load-bearing capacity models that indicated greater susceptibility to compaction were: in the 0-3 cm layer, HPos; in the 10-13 cm layer, GD and TC and in the 25-28 cm layer, HPre.Index terms: Coffee culture, soil compaction, sustainability, preconsolidation stress, soil structure. RESUMOO conhecimento dos níveis de pressão aplicados aos solos pelos diferentes manejos de plantas invasoras é essencial para adaptar o manejo de lavouras cafeeiras de forma sustentável. Os objetivos deste estudo foram: a) gerar os modelos de capacidade de suporte de carga de um Latossolo Vermelho-Amarelo submetido a diferentes manejos de plantas invasoras e b) determinar qual manejo resultou em maior compactação. O estudo foi realizado na Fazenda Experimental da EPAMIG, situada próxima a comunidade Farias, em Lavras-MG (latitude de 21° 14' 43" S e longitude 44° 59' 59" W e altitude de 919 m). O solo foi classificado como sendo um Latossolo Vermelho-Amarelo o qual vem sendo cultivado com cafeeiros da cutivar Topázio MG 1190, desde 2006. Foram avaliados cinco manejos de plantas invasoras sendo três, por meio do controle mecânico (grade de discos (GD), roçadora (RÇ) e trincha (TC),) e dois, por meio do controle químico (herbicida de pós-emergência (HPós), herbicida de pré-emergência (HPré)). Para a obtenção dos modelos de capacidade de suporte de carga, 10 amostras indeformadas de solo foram coletadas aleatoriamente nas camadas 0-3 e 10-13 e 25-28 cm nas entrelinhas do cafeeiro. Os modelos de capacidade de suporte de carga apontaram maior compactação do solo na camada de 0-3 cm para TC e GD; na camada 10-13 cm para HPre, HPos e RÇ e na camada 25-28 cm para GD; e indicaram maior suscetibilidade à compactação na camada de 0-3 cm para HPos; na camada 10-13 cm para GD e TC e na camada 25-28 cm para HPre.Ter...
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.