Northern clingfish use a ventral suction disc to stick to rough substrates in the intertidal zone. Bacteria, algae and invertebrates grow on these surfaces (fouling) and change the surface properties of the primary substrate, and therefore the attachment conditions for benthic organisms. In this study, we investigate the influence of fouling and surface roughness on the adhesive strength of northern clingfish, Gobiesox maeandricus. We measured clingfish tenacity on unfouled and fouled substrates over four surface roughnesses. We exposed surfaces for 6 weeks in the Pacific Ocean, until they were covered with periphyton. Clingfish tenacity is equivalent on both fouled and unfouled smooth substrates; however, tenacity on fouled rough surfaces is less compared with tenacity on unfouled ones. We hypothesize that parts of biofilm may act as a lubricant and decrease friction of the disc margin, thereby making disc margins slip inwards and fail at lower tenacities. Nevertheless, even on fouled surfaces the adhesive forces are approximately 150 times the body weight of the fish. To identify the upper threshold of surface roughness the fish can cling to, we tested seven unfouled substrates of increasing surface roughness. The threshold roughness at which northern clingfish failed increased with specimen size. We hypothesize that because of the elastic properties of the disc margin, a larger disc can adapt to larger surface irregularities. The largest specimens (length 10-12 cm) were able to cling to surfaces with 2-4 mm grain size. The fish can attach to surfaces with roughness between 2 and 9% of the suction disc width.

SummaryAnimal attachment to a substrate is very different in terrestrial and aquatic environments. We discuss variations in both the forces acting to detach animals and forces of attachment. While in a terrestrial environment gravity is commonly understood as the most important detachment force, under submerged conditions gravity is nearly balanced out by buoyancy and therefore matters little. In contrast, flow forces such as drag and lift are of higher importance in an aquatic environment. Depending on the flow conditions, flow forces can reach much higher values than gravity and vary in magnitude and direction. For many of the attachment mechanisms (adhesion including glue, friction, suction and mechanical principles such as hook, lock, clamp and spacer) significant differences have to be considered under water. For example, the main principles of dry adhesion, van der Waals forces and chemical bonding, which make a gecko stick to the ceiling, are weak under submerged conditions. Capillary forces are very important for wet adhesion, e.g., in terrestrial beetles or flies, but usually do not occur under water. Viscous forces are likely an important contributor to adhesion under water in some mobile animals such as torrent frogs and mayflies, but there are still many open questions to be answered. Glue is the dominant attachment mechanism of sessile aquatic animals and the aquatic realm presents many challenges to this mode of attachment. Viscous forces and the lack of surface tension under submerged conditions also affect frictional interactions in the aquatic environment. Moreover, the limitation of suction to the pressure difference at vacuum conditions can be ameliorated under water, due to the increasing pressure with water depth.

While artificial suction cups only attach well to smooth surfaces, the Northern clingfish can attach to surfaces ranging from nanoscale smooth to rough stone. This ability is highly desirable for technical applications. The morphology of the fish's suction disc and its ability to attach to rough and slimy surfaces have been described before, and here we aim to close gaps in the biomechanical understanding, and transfer the biomechanical principles to technical suction cups. We demonstrate that the margin of the suction disc is the critical feature enabling attachment to rough surfaces. Second, friction measurements show that friction of the disc rim is increased on rough substrates and contributes to high tenacity. Increased friction causes a delay in failure of the suction cup and increases the attachment force. We were able to implement these concepts to develop the first suction cups bioinspired by Northern clingfish. These cups attach with tenacities up to 70 kPa on surfaces as rough as 270 µm grain size. The application of this technology is promising in fields such as surgery, industrial production processes and whale tagging. This article is part of the theme issue ‘Transdisciplinary approaches to the study of adhesion and adhesives in biological systems'.