Inorganic CsPbI3 perovskite solar cells (PSCs) owning comparable photovoltaic performance and enhanced thermal stability compared to organic-inorganic hybrid perovskites have attracted enormous interest in the past year. However, it is still a challenge to stabilize the desired black α-CsPbI3 perovskites in ambient air for photovoltaic applications. Herein, sequential solvent engineering including the addition of hydroiodic acid (HI) and subsequent isopropanol (IPA) treatment for fabricating stable and working CsPbI3 PSCs is developed, and a novel low-temperature phase-transition route from new intermediate Cs4PbI6 to stable α-CsPbI3 is also released for the first time. As such, the as-prepared PSCs give a relatively high power conversion efficiency (PCE) of 4.13% (reverse scan), and the steady-state power output of 1.88% is confirmed for the selected cell with an initial PCE of 3.13%. To the best of our knowledge, this is the first demonstration of fabricating CsPbI3 inorganic PSCs under fully open-air conditions.

Recently, hybrid perovskite solar cells (PSCs) have attracted extensive attention due to their high efficiency and simple preparing process. Herein, a facile low-pressure chemical vapor deposition (LPCVD) technology is first developed to fabricate PSCs, which can effectively reduce the over-rapid intercalating reaction rate and easily overcome this blocking issue during the solution process. As a result, the prepared uniform perovskite films exhibit good crystallization, strong absorption, and long carrier diffusion length. More strikingly, CH3NH3PbI3 absorbers by LPCVD demonstrate excellent moisture-resistant feature even under laser illumination and high-temperature conditions, which indicates that our proprietary method is very suitable for the future low-cost, nonvacuum production of the new generation photovoltaic devices. Finally, high efficiency of 12.73% is successfully achieved under fully open-air conditions. To the best of our knowledge, this is the first report of efficient PSCs with such a high humidity above 60%.

No abstract

A simple ITCVD method is developed to fabricate PSCs, and their roll-over phenomenon in J–V curves is first investigated.