The aim of this study is to improve cladding process productivity by high production rate with low dilution process by specifying technique as hot-wire GMAW process. The base metal of carbon steel A516 Gr70 was cladded by austenitic stainless steel 309LSi for creating a buttering layer and stainless steel 308LSi for hot-wire filler for topping a cladding layer in a one-pass run. The studied parameters this experiment consist of the feeding ratio of hot wire feeding speed per GMAW wire feeding speed and travel speed. Welding phenomenon during welding was observed by CCD camera with specifying the optical device to see the appropriate condition. The result showed the hot-wire GMAW cladding process could reduce cycle time 3.5 times compare with conventional FCAW cladding process. Moreover, dilution of this process could decrease lower than 15% with acceptable FN 3 on the top of weld surface. Therefore, single pass cladding process achieved by using this method with low dilution by still keep microstructure capability.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
hi@scite.ai
10624 S. Eastern Ave., Ste. A-614
Henderson, NV 89052, USA
Copyright © 2024 scite LLC. All rights reserved.
Made with 💙 for researchers
Part of the Research Solutions Family.