In this paper, we describe the design and testing of a system for recording electroneurographic signals (ENG) from a multielectrode nerve cuff (MEC). This device, which is an extension of the conventional nerve signal recording cuff, enables ENG to be classified by action potential velocity. In addition to electrical measurements, we provide preliminary in vitro data obtained from frogs that demonstrate the validity of the technique for the first time. Since typical ENG signals are extremely small, on the order of 1 1 microV, very low-noise, high-gain amplifiers are required. The ten-channel system we describe was realized in a 0.8 microm CMOS technology and detailed measured results are presented. The overall gain is 10 000 and the total input-referred root mean square (rms) noise in a bandwidth 1 Hz-5 kHZ is 291 nV. The active area is 12 mm(2) and the power consumption is 24 mW from +/-2.5 V power supplies.

Abstract-This paper discusses certain important issues involved in the design of a nerve signal preamplifier for implantable neuroprostheses. Since the electroneurogram signal measured from cuff electrodes is typically on the order of 1 V, a very low-noise interface is essential. We present the argument for the use of BiCMOS technology in this application and then describe the design and evaluation of a complete preamplifier fabricated in a 0.8-m double-metal double-poly process. The preamplifier has a nominal voltage gain of 100, a bandwidth of 15 kHz, and a measured equivalent input-referred noise voltage spectral density of 3.3 nV Hz at 1 kHz. The total input-referred rms noise voltage in a bandwidth 1 Hz-10 kHz is 290 nV, the power consumption is 1.3 mW from 2.5-V power supplies, and the active area is 0.3 mm 2 .

Abstract-This paper presents an integrated fully differential current driver for wearable multi-frequency electrical impedance tomography (EIT). The integrated circuit (IC) comprises a wideband current driver (up to 500 kHz) functioning as the master for current sourcing, and a differential voltage receiver with common-mode feedback configuration as the slave for current sinking. The IC is fabricated in a 0.18-µm CMOS technology. It operates from ±1.65 V power supplies and occupies a total die area of less than 0.05 mm 2 . The current driver has a measured output impedance of 750 kΩ at 500 kHz and provides a common-mode signal reduction of 32 dB at 500 kHz. The application of the IC in a wearable EIT lung monitoring system is presented.

Common mode voltages are frequently a problem in electrical impedance tomography (EIT) and other bioimpedance applications. To reduce their amplitude common mode feedback is employed. Formalised analyses of both current and voltage feedback is presented in this paper for current drives. Common mode effects due to imbalances caused by the current drives, the electrode connections to the body load and the introduction of the body impedance to ground are considered. Frequency selective narrowband common mode feedback previously proposed to provide feedback stability is examined. As a step towards multifrequency applications the use of narrowband feedback is experimentally demonstrated for two simultaneous current drives. Measured results using standard available components show a reduction of 62 dB for current feedback and 31 dB for voltage feedback. Frequencies ranged from 50 kHz to 1 MHz.

Full bibliographic details must be given when referring to, or quoting from full items including the author's name, the title of the work, publication details where relevant (place, publisher, date), pagination, and for theses or dissertations the awarding institution, the degree type awarded, and the date of the award.